Operation panel and FR-PA07

Since the operation panel and PU connector cannot be specified for command source at the same time, they cannot be used together. More Details >>

Parameter copy

The copy function of the parameter unit (FR-PU04) is not available. Setting each parameter again or using the convert function of FR Configurator (FR-SW3-SET... More Details >>

Connection cable of FR-Configurator

The following USB connectors are available.For FR-A700: USB B connector (B receptacle)For FR-E700: USB Mini-B connector (Mini-B receptacle) Use the USB cable... More Details >>

Writing set frequency by CC-Link communication

No error will occur because up to 400 Hz that is the upper limit of the setting range can be written. More Details >>

Communication EEPROM write selection (Pr.342)

They are cleared by the RES signal from the external terminals or inverter reset from the communication. More Details >>

FR Configurator SW3 (CC-Link Seamless)

It is supports FR Configurator Ver.4.90 or later. More Details >>

Setting resolution switching

Check the setting value of Pr.37 (Speed display). When the machine speed is set, Pr.811 is disabled. Change the setting to the rotation speed. More Details >>

FR-CV

The reactor generates a sound during power regeneration, but it is not abnormal. [Reason] The noise from the reactor is caused mainly by the magnetic attract... More Details >>

FR-HC2

It controls the charging current immediately after the power is ON. (as a MC (magnetic contactor) for the charging current limit circuit, etc) More Details >>

FR-A800

Number of terminals: Same input terminals as the A700 series, and the following two terminals are added. Safety: SI1, SI2, SIC 24 V power supply: +24 * The t... More Details >>