Anti-sway control

Set 3 kg (intermediate value) for the load weight 1 to 5 kg. More Details >>

Sampling time of FR Configurator2

It depends on the mask count. It is approximately 0.125 [ms] (mask count: 1) to 20 [ms] (mask count: 30). More Details >>

CC-Link

For output signals, up to 10 points (RXn2 to RXB) can be assigned. It is possible if the number of the importing signal points are within this range. More Details >>

Terminal 2 input selector switch when the PTC thermistor is connected

When the DIP switch is changed to I, it does not operate normally because the internal resistance changes. More Details >>

Installation of the FR-PA07

Yes, because the same enclosure cut dimensions is adopted. More Details >>

Switching from star-delta operation

It is probable that the torque is insufficient because the load characteristics and inverter output characteristics do not match and the output current value... More Details >>

Countermeasure against harmonics

The following countermeasure against harmonics is available with the inverter.The values are quoted from the harmonic suppression guidelines.1. Insert the AC... More Details >>

Motor heat generation

The surface temperature of approximately 70?C is OK.The following shows the MM-CF352 frame temperature for reference.(Actual temperature rise depends on how ... More Details >>

External thermal overheat

Take the following countermeasure:1. If the thermal trips in low-speed operation, trips can be avoided, depending on the external thermal relay operation cha... More Details >>

400 Hz output setting

Change Pr.18 (High speed maximum frequency) to 400 Hz.If you are using the analog command to set the frequency, calibrate the 400 Hz frequency with Pr.903. More Details >>