Seamless communication of FR Configurator SW3

The communication via the MELSECNET is not available. More Details >>

SW1DND-FRC2 (FR Configurator2)

Check the setting value of Pr.414 (PLC function operation selection) and if the initial value: 0 (PLC function disabled) is set, set "1" or "2" and enable th... More Details >>

What type of personal computer is required?

The PC platform can be PC98 or DOS/V as far as Windows 3.1 or Windows 95 runs smoothly, with free space of 1 MB or more on the hard disk, and memory (RAM) 1 ... More Details >>

How many inverters can be connected?

Up to 32 units can be connected. (This is because the inverter communication conforms to RS-485.) More Details >>

Not operating on Windows95

This error depends on the application and the cause is unknown. (The runtime error '31037' is not returned from this application but from the OS (Windows).) ... More Details >>

FR Configurator2

Up to 20 pieces of sampling data can be saved. The oldest data is overwritten when more than 20 pieces of data are to be saved. More Details >>

Inverter setup

Set the parameters below. For other parameters, keep the initial settings.1.　Set Pr.122 (Communication check time interval) to other than "0". ("9999" is OK.... More Details >>

Communication fault occurs

The possible causes are as follows. While the inverter power supply is turned ON, inserting the modular jack to the connector with the operation panel remove... More Details >>

Can I set the FR-F series parameters?

The FREQROL-F500 series has been already supported by the setup software released since February 2000. More Details >>

FR-SW1-SETUP

It is one of other communication errors. The communication is not established. Check the communication settings. More Details >>