Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

91-100 of Total 129

prev 10 / 13page next

  • FR-HC2

    It prevents high-frequency current due to switching that is output by the FR-HC2 from being flown into the power supply system as a filter. More Details >>

    • No：21151
    • Release Date：2018/08/22 16:26

  • FR-HAL

    The UL94V-0 flammability standard is satisfied. More Details >>

    • No：20990
    • Release Date：2018/08/22 16:25

  • Connection of the FR-HAL

    Yes. More Details >>

    • No：20985
    • Release Date：2018/08/22 16:25

  • FR-PU07BB

    Because the internal reset processing is performed when the power supply is turned OFF, the fault state cannot be held. The details of the faults are saved i... More Details >>

    • No：20942
    • Release Date：2018/08/22 16:25

  • FR-HC2

    The internal transistor of the HC2 stops by turning on the SOF signal and stopping the converter. As a result, regenerative driving is not performed. However... More Details >>

    • No：20941
    • Release Date：2018/08/22 16:25

  • Combination of the FR-F800 and FR-A8TAT

    Yes, it can. For the capacity of 37K or more, use the included bracket for installation. More Details >>

    • No：20841
    • Release Date：2018/08/22 16:24

  • FR-HC/FR-HC2

    No, it cannot. Use the FR-HC2 dedicated reactor and outside box. More Details >>

    • No：20807
    • Release Date：2018/08/22 16:24

  • System configuration

    The whole system consists of the power supply, molded case circuit breaker, high power factor converter, inverter, and motor. The high power factor converter... More Details >>

    • No：21575
    • Release Date：2018/08/22 16:28

  • Connecting multiple inverters to single high power factor converter

    Up to 6 units. If you connect 7 or more inverters, the permissible output of control signals is exceeded. Be sure to use a high power factor converter with t... More Details >>

    • No：21566
    • Release Date：2018/08/22 16:28

  • Influence on leakage current

    Since the converter in the high power factor converter section performs PWM switching, the leakage current increases to the same level as the general-purpose... More Details >>

    • No：21558
    • Release Date：2018/08/22 16:28

91-100 of Total 129

Inquiries

Contact Us

page top