Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ Options ]

111-120 of Total 129

prev 12 / 13page next
  • FR-A800 and FR-ALF

    Yes, it can. More Details >>

    • No:20806
    • Release Date:2018/08/22 16:24
  • Connection of options

    1. As the reactor (FR-HCL) is connected when connecting the FR-HC, do not connect the FR-BAL. 2. The noise filter can be connected to the input side of the F... More Details >>

    • No:22101
    • Release Date:2018/08/22 16:30
  • Regenerative driving capability

    Continuous 100% regenerative braking torque is available for the rated capacity of the high power factor converter. (The same braking ability of the FR-A201 ... More Details >>

    • No:21563
    • Release Date:2018/08/22 16:28
  • Countermeasure against harmonics

    Perform calculation given in the harmonic suppression guidelines, and if the limit value is exceeded, you may also need to insert the ACL. Note that you cann... More Details >>

    • No:21465
    • Release Date:2018/08/22 16:27
  • FR-HC2

    The power of MC1 is supplied from the terminals across R2 and S2 of the outside box. Either phase of R2 or S2 may be lost. More Details >>

    • No:21146
    • Release Date:2018/08/22 16:26
  • Leakage current of the FR-BIF

    For the 200 V type, the leakage current at the delta connection is 5 mA. For the 400 V type, it is 10 mA. More Details >>

    • No:20835
    • Release Date:2018/08/22 16:24
  • FR-XC

    - Both 200 V and 400 V can be used only with the capacity 22 kW or higher. - The rated current (capacity) is derated. (For the detail, refer to the Instructi... More Details >>

    • No:20802
    • Release Date:2018/08/22 16:24
  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No:21574
    • Release Date:2018/08/22 16:28
  • What happens if the supplied reactor and outside box are not used?

    Harmonics cannot be suppressed (controlled) correctly and noise cannot be removed. Be sure to connect the supplied reactor and outside box to the inverter. More Details >>

    • No:21557
    • Release Date:2018/08/22 16:28
  • Control cable between high power factor converter and inverter

    Connect the high power factor converter and inverter directly with a control cable, without using a relay. Since a fast-response is required to shut off the ... More Details >>

    • No:21555
    • Release Date:2018/08/22 16:28

111-120 of Total 129

Inquiries