Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ Options ]

121-129 of Total 129

prev 13 / 13page next
  • FR-HC2

    It controls the charging current immediately after the power is ON. (as a resistor for charging current limit circuit) More Details >>

    • No:21150
    • Release Date:2018/08/22 16:26
  • FR-HC2

    It controls the charging current immediately after the power is ON. (as a MC (magnetic contactor) for the charging current limit circuit, etc) More Details >>

    • No:21149
    • Release Date:2018/08/22 16:26
  • FR-A8ND

    Input "0" to the bit not to be sent. More Details >>

    • No:20970
    • Release Date:2018/08/22 16:25
  • Power supply capacity

    Since the input power factor is improved to approximately 1, the power supply capacity can be reduced to 2/3 to 3/4 of an inverter without a power factor imp... More Details >>

    • No:21556
    • Release Date:2018/08/22 16:28
  • FR-HC2

    Three phases are measured with the CT. The accuracy is ±10 % which is same as the inverter output current. More Details >>

    • No:21145
    • Release Date:2018/08/22 16:26
  • Line noise filter

    Yes. However, it is difficult to wind the twisted wires because they are thick. More Details >>

    • No:21128
    • Release Date:2018/08/22 16:26
  • Connection of the FR-HEL

    Yes. More Details >>

    • No:20987
    • Release Date:2018/08/22 16:25
  • FR-HC2

    The internal transistor of the HC2 stops by turning on the SOF signal and stopping the converter. As a result, regenerative driving is not performed. However... More Details >>

    • No:20941
    • Release Date:2018/08/22 16:25
  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No:21574
    • Release Date:2018/08/22 16:28

121-129 of Total 129

Inquiries