Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

11-20 of Total 127

prev 2 / 13page next

  • Influence on leakage current

    Since the converter in the high power factor converter section performs PWM switching, the leakage current increases to the same level as the general-purpose... More Details >>

    • No：21558
    • Release Date：2018/08/22 16:28

  • Line noise filter

    Yes. However, it is difficult to wind the twisted wires because they are thick. More Details >>

    • No：21128
    • Release Date：2018/08/22 16:26

  • FR-HC2

    Three phases are measured with the CT. The accuracy is ±10 % which is same as the inverter output current. More Details >>

    • No：21145
    • Release Date：2018/08/22 16:26

  • FR-HC2

    Perform the writing after turning ON the SOF, or after stopping the FR-HC2 by pressing the STOP button. Wire the RDY signal so that the inverter stops when t... More Details >>

    • No：20842
    • Release Date：2018/08/22 16:24

  • FR-HAL/HEL

    For 200 V: The cover is attached for 15 K or lower. No cover is attached for 18.5 K or higher. For 400 V: The cover is attached for 55 K or lower. No cover i... More Details >>

    • No：20988
    • Release Date：2018/08/22 16:25

  • FR-HC2

    A current fluctuation may result in abnormal noise from the peripheral device or the flickering fluorescent light. More Details >>

    • No：21155
    • Release Date：2018/08/22 16:26

  • Protective functions

    Protective functions against the power supply fault, overcurrent, element fault, undervoltage, and transistor thermal fault (inverter protection) are availab... More Details >>

    • No：21567
    • Release Date：2018/08/22 16:28

  • Harmonic suppression guidelines for power supply

    Since the high power factor converter uses the self-excitation three-phase bridge (voltage type PWM control) circuit configuration (type), the conversion coe... More Details >>

    • No：21572
    • Release Date：2018/08/22 16:28

  • FR-CVL

    Keep a clearance of "minimum 10cm each on top and bottom and minimum 5cm each on right and left". More Details >>

    • No：21178
    • Release Date：2018/08/22 16:26

  • FR-ASF

    Yes. More Details >>

    • No：20986
    • Release Date：2018/08/22 16:25

11-20 of Total 127

Inquiries

Contact Us

page top