Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

21-30 of Total 129

prev 3 / 13page next

  • FR-XC

    The power factor is 0.99 or more (at rated load). More Details >>

    • No：20803
    • Release Date：2018/08/22 16:24

  • Power factor improving reactor

    Your understanding about the AC and DC reactors is correct. For the harmonics suppression effect obtained by using both types of reactors, refer to the table... More Details >>

    • No：21994
    • Release Date：2018/08/22 16:30

  • Phase detection terminal

    The phase detection terminal has been provided with units produced since December 1999. You can identify these units with the serial number "N9Z○○○○○○" or la... More Details >>

    • No：22090
    • Release Date：2018/08/22 16:30

  • Brake unit selection

    1. The BU brake unit does not have the fault output.Multiple BU brake units can be connected in parallel.2. Power supply voltage 480 V- What resistance value... More Details >>

    • No：21930
    • Release Date：2018/08/22 16:30

  • Control wire of FR-HC RDY signal

    The contact between the terminals RDY and SE is open collector output.Operation is:Normal: Non-conductiveFault: Conductive More Details >>

    • No：22017
    • Release Date：2018/08/22 16:30

  • FR-HC2

    It controls the charging current immediately after the power is ON. (as a MC (magnetic contactor) for the charging current limit circuit, etc) More Details >>

    • No：21149
    • Release Date：2018/08/22 16:26

  • Influence on noise level

    By using the reactors 1 and 2 as well as the outside box supplied with the high power factor converter, while the noise may increase or decrease depending th... More Details >>

    • No：21559
    • Release Date：2018/08/22 16:28

  • What happens if the supplied reactor and outside box are not used?

    Harmonics cannot be suppressed (controlled) correctly and noise cannot be removed. Be sure to connect the supplied reactor and outside box to the inverter. More Details >>

    • No：21557
    • Release Date：2018/08/22 16:28

  • Connection point of the line noise filter

    Connect the line noise filter between the inverter and EMC Directive compliant noise filter. More Details >>

    • No：20818
    • Release Date：2018/08/22 16:24

  • Installing reactor for suppressing harmonics

    You can connect multiple inverters to a single reactor. In this case, the load seems to be light from the reactor unless all of the inverters are rotating an... More Details >>

    • No：21410
    • Release Date：2018/08/22 16:27

21-30 of Total 129

Inquiries

Contact Us

page top