Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

31-40 of Total 129

prev 4 / 13page next

  • FR-HC2

    Perform the writing after turning ON the SOF, or after stopping the FR-HC2 by pressing the STOP button. Wire the RDY signal so that the inverter stops when t... More Details >>

    • No：20842
    • Release Date：2018/08/22 16:24

  • Leakage current of the FR-BIF

    For the 200 V type, the leakage current at the delta connection is 5 mA. For the 400 V type, it is 10 mA. More Details >>

    • No：20835
    • Release Date：2018/08/22 16:24

  • FR-RC selection

    1. The 100% braking torque means the 100% motor rated torque. Do not consider the continuous regenerative driving based on the braking torque. Consider the r... More Details >>

    • No：22023
    • Release Date：2018/08/22 16:30

  • Combination with existing inverters

    Since the existing inverters do not have a terminal to connect to the FR-HC, it cannot be connected to them. Use an inverter compatible with the high power f... More Details >>

    • No：21569
    • Release Date：2018/08/22 16:28

  • Noise filter

    Noise filtering and harmonics suppression are different matters and you need to install the line noise filter (FR-BSF01) against noise and DCL (FR-BEL) again... More Details >>

    • No：21548
    • Release Date：2018/08/22 16:28

  • Difference between use with A100 and other types

    Similarly to the FR-A200 and A500, four or more filters should be used also for the FR-A100. 　In short, it is OK if the wire penetrates the filter four times... More Details >>

    • No：21468
    • Release Date：2018/08/22 16:27

  • Line noise filter

    Yes. However, it is difficult to wind the twisted wires because they are thick. More Details >>

    • No：21128
    • Release Date：2018/08/22 16:26

  • Control terminal block

    It is available if the option FR-A8TAT (Control circuit terminal block intercompatibility attachment) is installed. (Some functions have restrictions. For th... More Details >>

    • No：21087
    • Release Date：2018/08/22 16:25

  • Use of the FR-RC

    Yes. More Details >>

    • No：21062
    • Release Date：2018/08/22 16:25

  • FR-HAL/HEL

    For 200 V: The cover is attached for 15 K or lower. No cover is attached for 18.5 K or higher. For 400 V: The cover is attached for 55 K or lower. No cover i... More Details >>

    • No：20988
    • Release Date：2018/08/22 16:25

31-40 of Total 129

Inquiries

Contact Us

page top