Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

41-50 of Total 129

prev 5 / 13page next

  • Countermeasure against harmonics

    Perform calculation given in the harmonic suppression guidelines, and if the limit value is exceeded, you may also need to insert the ACL. Note that you cann... More Details >>

    • No：21465
    • Release Date：2018/08/22 16:27

  • Difference between use with A100 and other types

    Similarly to the FR-A200 and A500, four or more filters should be used also for the FR-A100. 　In short, it is OK if the wire penetrates the filter four times... More Details >>

    • No：21468
    • Release Date：2018/08/22 16:27

  • What is the replacement of the FR-BOL?

    We do not offer a replacement product for the FR-BOL (noise reduction reactor). Since the FR-A100E is a low-noise type inverter, the motor noise is suppresse... More Details >>

    • No：21500
    • Release Date：2018/08/22 16:27

  • Control cable between high power factor converter and inverter

    Connect the high power factor converter and inverter directly with a control cable, without using a relay. Since a fast-response is required to shut off the ... More Details >>

    • No：21555
    • Release Date：2018/08/22 16:28

  • Power supply capacity

    Since the input power factor is improved to approximately 1, the power supply capacity can be reduced to 2/3 to 3/4 of an inverter without a power factor imp... More Details >>

    • No：21556
    • Release Date：2018/08/22 16:28

  • Influence on leakage current

    Since the converter in the high power factor converter section performs PWM switching, the leakage current increases to the same level as the general-purpose... More Details >>

    • No：21558
    • Release Date：2018/08/22 16:28

  • Influence on noise level

    By using the reactors 1 and 2 as well as the outside box supplied with the high power factor converter, while the noise may increase or decrease depending th... More Details >>

    • No：21559
    • Release Date：2018/08/22 16:28

  • Output voltage

    The output voltage is approximately 300 VDC for the 200 V class and approximately 600 VDC for the 400 V class. 　The output voltage fluctuates due to fluctuat... More Details >>

    • No：21561
    • Release Date：2018/08/22 16:28

  • Regenerative driving capability

    Continuous 100% regenerative braking torque is available for the rated capacity of the high power factor converter. (The same braking ability of the FR-A201 ... More Details >>

    • No：21563
    • Release Date：2018/08/22 16:28

  • Inverter selection when multiple inverters are to be connected

    Be sure to use a high power factor converter with the capacity higher than the total capacity of the inverters connected. (Note: One or more of the inverters... More Details >>

    • No：21565
    • Release Date：2018/08/22 16:28

41-50 of Total 129

Inquiries

Contact Us

page top