Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

41-50 of Total 129

prev 5 / 13page next

  • System configuration

    The whole system consists of the power supply, molded case circuit breaker, high power factor converter, inverter, and motor. The high power factor converter... More Details >>

    • No：21575
    • Release Date：2018/08/22 16:28

  • FR-CVL

    Keep a clearance of "minimum 10cm each on top and bottom and minimum 5cm each on right and left". More Details >>

    • No：21178
    • Release Date：2018/08/22 16:26

  • FR-CV

    At power-ON, the signal turns ON for a moment to perform a converter initial reset. More Details >>

    • No：21156
    • Release Date：2018/08/22 16:26

  • FR-HC2

    It bypasses (removes) high-frequency current due to switching that is output by the FR-HC2 to prevent it from being flown into the power supply system as a f... More Details >>

    • No：21152
    • Release Date：2018/08/22 16:26

  • FR-A842

    The inrush current limit circuit is not built in the FR-A842 (inverter unit). It is built in the FR-CC2 (converter unit), which is combined with the FR-A842.... More Details >>

    • No：21059
    • Release Date：2018/08/22 16:25

  • Brake unit selection

    1. The BU brake unit does not have the fault output.Multiple BU brake units can be connected in parallel.2. Power supply voltage 480 V- What resistance value... More Details >>

    • No：21930
    • Release Date：2018/08/22 16:30

  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No：21574
    • Release Date：2018/08/22 16:28

  • Influence on noise level

    By using the reactors 1 and 2 as well as the outside box supplied with the high power factor converter, while the noise may increase or decrease depending th... More Details >>

    • No：21559
    • Release Date：2018/08/22 16:28

  • FR-HC2

    Because RSO (converter reset) of the HC2 is connected to RES of the inverter, the inverter is reset along with the HC2 reset. (Refer to the wiring diagram in... More Details >>

    • No：20948
    • Release Date：2018/08/22 16:25

  • Control wire of FR-HC RDY signal

    The contact between the terminals RDY and SE is open collector output.Operation is:Normal: Non-conductiveFault: Conductive More Details >>

    • No：22017
    • Release Date：2018/08/22 16:30

41-50 of Total 129

Inquiries

Contact Us

page top