Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

51-60 of Total 127

prev 6 / 13page next

  • FR-PU07BB

    Because the internal reset processing is performed when the power supply is turned OFF, the fault state cannot be held. The details of the faults are saved i... More Details >>

    • No：20942
    • Release Date：2018/08/22 16:25

  • Power factor improving reactor

    Your understanding about the AC and DC reactors is correct. For the harmonics suppression effect obtained by using both types of reactors, refer to the table... More Details >>

    • No：21994
    • Release Date：2018/08/22 16:30

  • FR-PA07

    No, it cannot. The standard operation panel (FR-DU08) can be connected to the face of the board by using the FR-ADP (operation panel connection connector) an... More Details >>

    • No：20898
    • Release Date：2018/08/22 16:24

  • FR-HC2

    Perform the writing after turning ON the SOF, or after stopping the FR-HC2 by pressing the STOP button. Wire the RDY signal so that the inverter stops when t... More Details >>

    • No：20842
    • Release Date：2018/08/22 16:24

  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No：21574
    • Release Date：2018/08/22 16:28

  • Protective functions

    Protective functions against the power supply fault, overcurrent, element fault, undervoltage, and transistor thermal fault (inverter protection) are availab... More Details >>

    • No：21567
    • Release Date：2018/08/22 16:28

  • FR-E700-SC

    Not available for the FR-E700-SC. For the 485 communication with the terminal block, use the standard FR-E700. More Details >>

    • No：21130
    • Release Date：2018/08/22 16:26

  • Connection of the FR-HEL

    Yes. More Details >>

    • No：20987
    • Release Date：2018/08/22 16:25

  • Installation of a reactor

    The answers are as follows:- Effect of reactorAttaching a reactor improves the power factor and suppresses harmonics.The AC reactor improves the power factor... More Details >>

    • No：22092
    • Release Date：2018/08/22 16:30

  • Installation method

    If multiple line noise filters are wound without clearance between them, the noise reduction effect corresponding to the number of filters cannot be obtained... More Details >>

    • No：22087
    • Release Date：2018/08/22 16:30

51-60 of Total 127

Inquiries

Contact Us

page top