Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

61-70 of Total 127

prev 7 / 13page next

  • FR-HC2

    Perform the writing after turning ON the SOF, or after stopping the FR-HC2 by pressing the STOP button. Wire the RDY signal so that the inverter stops when t... More Details >>

    • No：20842
    • Release Date：2018/08/22 16:24

  • FR-A800 and FR-ALF

    Yes, it can. More Details >>

    • No：20806
    • Release Date：2018/08/22 16:24

  • Connecting multiple inverters to single high power factor converter

    Up to 6 units. If you connect 7 or more inverters, the permissible output of control signals is exceeded. Be sure to use a high power factor converter with t... More Details >>

    • No：21566
    • Release Date：2018/08/22 16:28

  • Regenerative power flow

    If all inverters are in regenerative operation, the regenerative power is regenerated to the power supply. If one of the inverters is power driving, the rege... More Details >>

    • No：21564
    • Release Date：2018/08/22 16:28

  • Power supply capacity

    Since the input power factor is improved to approximately 1, the power supply capacity can be reduced to 2/3 to 3/4 of an inverter without a power factor imp... More Details >>

    • No：21556
    • Release Date：2018/08/22 16:28

  • Noise filter

    Noise filtering and harmonics suppression are different matters and you need to install the line noise filter (FR-BSF01) against noise and DCL (FR-BEL) again... More Details >>

    • No：21548
    • Release Date：2018/08/22 16:28

  • FR-BIF

    It is available. Insulate the raised wiring of T-phase. More Details >>

    • No：21177
    • Release Date：2018/08/22 16:26

  • FR-HC2

    It prevents high-frequency current due to switching that is output by the FR-HC2 from being flown into the power supply system as a filter. More Details >>

    • No：21151
    • Release Date：2018/08/22 16:26

  • FR-A8ND

    Input "0" to the bit not to be sent. More Details >>

    • No：20970
    • Release Date：2018/08/22 16:25

  • FR-HC2

    No OL signal is output. More Details >>

    • No：20870
    • Release Date：2018/08/22 16:24

61-70 of Total 127

Inquiries

Contact Us

page top