Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ Options ]

71-80 of Total 129

prev 8 / 13page next
  • Connection of options

    1. As the reactor (FR-HCL) is connected when connecting the FR-HC, do not connect the FR-BAL. 2. The noise filter can be connected to the input side of the F... More Details >>

    • No:22101
    • Release Date:2018/08/22 16:30
  • Fault output terminal load pattern

    The fault output terminals A and C, and B and C of the power regeneration converter FR-RC are not capable of a micro load of 5 VDC±5%, 10 mA. The minimum loa... More Details >>

    • No:21966
    • Release Date:2018/08/22 16:30
  • Harmonic suppression guidelines for power supply

    Since the high power factor converter uses the self-excitation three-phase bridge (voltage type PWM control) circuit configuration (type), the conversion coe... More Details >>

    • No:21572
    • Release Date:2018/08/22 16:28
  • Regenerative power flow

    If all inverters are in regenerative operation, the regenerative power is regenerated to the power supply. If one of the inverters is power driving, the rege... More Details >>

    • No:21564
    • Release Date:2018/08/22 16:28
  • Inverter built-in fuse

    For the inverter with capacity of 160K or higher, the fuse is built in its DC part. More Details >>

    • No:20940
    • Release Date:2018/08/22 16:25
  • FR-HC2

    No OL signal is output. More Details >>

    • No:20870
    • Release Date:2018/08/22 16:24
  • FR-HC2

    Perform the writing after turning ON the SOF, or after stopping the FR-HC2 by pressing the STOP button. Wire the RDY signal so that the inverter stops when t... More Details >>

    • No:20842
    • Release Date:2018/08/22 16:24
  • Control wire of FR-HC RDY signal

    The contact between the terminals RDY and SE is open collector output.Operation is:Normal: Non-conductiveFault: Conductive More Details >>

    • No:22017
    • Release Date:2018/08/22 16:30
  • FR-A8TAT

    The output of the FM terminal becomes the current output of the CA. More Details >>

    • No:21060
    • Release Date:2018/08/22 16:25
  • Installation of a reactor

    The answers are as follows:- Effect of reactorAttaching a reactor improves the power factor and suppresses harmonics.The AC reactor improves the power factor... More Details >>

    • No:22092
    • Release Date:2018/08/22 16:30

71-80 of Total 129

Inquiries