Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

71-80 of Total 127

prev 8 / 13page next

  • Model configuration

    For the 200 V class, the 7.5K, 15K, 30K, and 55K models are available. For the 400 V class, the 7.5K, 15K, 30K, and 55K models are available. Each requires t... More Details >>

    • No：21576
    • Release Date：2018/08/22 16:28

  • Using a higher grade power factor improving reactor

    Using a reactor under a load lighter than the rated capacity slightly spoils its effect in improving the power factor.Therefore, you should use a reactor wit... More Details >>

    • No：21935
    • Release Date：2018/08/22 16:30

  • TH3 terminal of the MT-BR5

    The resistor unit MT-BR5 manufactured in February 2016 or later has output terminal TH3 (NC contact) as a fault output terminal. More Details >>

    • No：20816
    • Release Date：2018/08/22 16:24

  • Leakage current of the FR-BIF

    For the 200 V type, the leakage current at the delta connection is 5 mA. For the 400 V type, it is 10 mA. More Details >>

    • No：20835
    • Release Date：2018/08/22 16:24

  • Influence on noise level

    By using the reactors 1 and 2 as well as the outside box supplied with the high power factor converter, while the noise may increase or decrease depending th... More Details >>

    • No：21559
    • Release Date：2018/08/22 16:28

  • FR-HAL/FR-HEL selection

    Not required. Select it according to the capacity of the vector motor used. More Details >>

    • No：20804
    • Release Date：2018/08/22 16:24

  • FR-HC/FR-HC2

    No, it cannot. Use the FR-HC2 dedicated reactor and outside box. More Details >>

    • No：20807
    • Release Date：2018/08/22 16:24

  • FR-HC2

    Because RSO (converter reset) of the HC2 is connected to RES of the inverter, the inverter is reset along with the HC2 reset. (Refer to the wiring diagram in... More Details >>

    • No：20948
    • Release Date：2018/08/22 16:25

  • FR-A5CN

    When the heat sink is outside, since the heat sink and fan are not waterproof, you need to enclose them so that they are not exposed to the spray of water. More Details >>

    • No：21435
    • Release Date：2018/08/22 16:27

  • Input power factor

    To almost "1". (With load factor of 100%) More Details >>

    • No：21577
    • Release Date：2018/08/22 16:28

71-80 of Total 127

Inquiries

Contact Us

page top