Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Options ]

81-90 of Total 129

prev 9 / 13page next

  • FR-B/FR-B3

    Yes. More Details >>

    • No：21063
    • Release Date：2018/08/22 16:25

  • Inverter selection when multiple inverters are to be connected

    Be sure to use a high power factor converter with the capacity higher than the total capacity of the inverters connected. (Note: One or more of the inverters... More Details >>

    • No：21565
    • Release Date：2018/08/22 16:28

  • Accessories and inverter with built-in high power factor converter

    If the reactor 1, outside box, and reactor 2 are contained in the same case as the high power factor converter, the unit becomes larger and heavier while fre... More Details >>

    • No：21573
    • Release Date：2018/08/22 16:28

  • FR-HC2

    Because RSO (converter reset) of the HC2 is connected to RES of the inverter, the inverter is reset along with the HC2 reset. (Refer to the wiring diagram in... More Details >>

    • No：20948
    • Release Date：2018/08/22 16:25

  • FR-HC2

    It bypasses (removes) high-frequency current due to switching that is output by the FR-HC2 to prevent it from being flown into the power supply system as a f... More Details >>

    • No：21152
    • Release Date：2018/08/22 16:26

  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No：21574
    • Release Date：2018/08/22 16:28

  • FR-A842

    The inrush current limit circuit is not built in the FR-A842 (inverter unit). It is built in the FR-CC2 (converter unit), which is combined with the FR-A842.... More Details >>

    • No：21059
    • Release Date：2018/08/22 16:25

  • FR-CVL

    Keep a clearance of "minimum 10cm each on top and bottom and minimum 5cm each on right and left". More Details >>

    • No：21178
    • Release Date：2018/08/22 16:26

  • Noise filter

    Noise filtering and harmonics suppression are different matters and you need to install the line noise filter (FR-BSF01) against noise and DCL (FR-BEL) again... More Details >>

    • No：21548
    • Release Date：2018/08/22 16:28

  • Regenerative power flow

    If all inverters are in regenerative operation, the regenerative power is regenerated to the power supply. If one of the inverters is power driving, the rege... More Details >>

    • No：21564
    • Release Date：2018/08/22 16:28

81-90 of Total 129

Inquiries

Contact Us

page top