Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Plug-in Options ]

11-20 of Total 30

prev 2 / 3page next

  • CC-Link

    For output signals, up to 10 points (RXn2 to RXB) can be assigned. It is possible if the number of the importing signal points are within this range. More Details >>

    • No：20943
    • Release Date：2018/08/22 16:25

  • FR-A8NC

    Because the inverter status reading is stopped by the processing such as PLC in the inverter when the main circuit turns ON. It is stopped for approximately ... More Details >>

    • No：20873
    • Release Date：2018/08/22 16:24

  • Plug-in options

    Use the plug-in option dedicated for the FR-A200EXECLLENT. The plug-in option for the FR-A200EXECLLENT cannot be used with the FR-A200. To avoid installing a... More Details >>

    • No：21634
    • Release Date：2018/08/22 16:28

  • Plug-in options

    You cannot reuse the plug-in option for the FREQROL-A200 and A100 series. You must use one of the following three plug-in options dedicated to the FREQROL-V2... More Details >>

    • No：21656
    • Release Date：2018/08/22 16:28

  • FR-A8AZ

    Not available. When using the motor thermistor function, use the dedicated motor V5RU with a thermistor. More Details >>

    • No：21003
    • Release Date：2018/08/22 16:25

  • Compatibility of plug-in option

    Use the plug-in option dedicated for the FR-A100EXCELLENT. To avoid an incorrect installation, the connector position for the plug-in option and the FR-A100E... More Details >>

    • No：21632
    • Release Date：2018/08/22 16:28

  • FR-A8AL

    When the PG24 terminal and the PG terminal are shorted, 24 VDC power for the encoder can be supplied from the PG24 terminal. More Details >>

    • No：20954
    • Release Date：2018/08/22 16:25

  • CC-Link

    The corresponding bit (RYB) can be used when a function other than reset is assigned to the RES terminal, but it cannot be used as the reset function. Use RY... More Details >>

    • No：21142
    • Release Date：2018/08/22 16:26

  • Encoder feedback speed accuracy

    The speed variation rate is as follows: 　- Encoder feedback control: ±0.2% - Vector control: ±0.02% (mentioned in FR-A5AP Instruction Manual) More Details >>

    • No：21422
    • Release Date：2018/08/22 16:27

  • FR-A8AY

    The response delay time is 10 ms normally and 100 ms at startup. More Details >>

    • No：20821
    • Release Date：2018/08/22 16:24

11-20 of Total 30

Inquiries

Contact Us

page top