Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

101-110 of Total 142

prev 11 / 15page next

  • FR-A800-R2R

    If Pr.361 = 0, the second terminal can be used as the line speed command when X114 is ON, and as the frequency setting value when X114 is OFF. If Pr.361 = 3,... More Details >>

    • No：20891
    • Release Date：2018/08/22 16:24

  • FR-A800-R2R

    They cannot be set with the frequency. Because the command is input at the line speed, consider the line speed of the initial winding diameter at 20 Hz. The ... More Details >>

    • No：20888
    • Release Date：2018/08/22 16:24

  • Use of the FR-RC

    Yes. More Details >>

    • No：21062
    • Release Date：2018/08/22 16:25

  • MM-FR-A800

    If the command is 0.01 Hz or higher, the positioning control is performed. More Details >>

    • No：21001
    • Release Date：2018/08/22 16:25

  • FR-A800-2

    The output turns OFF (0 mA) during the inverter reset. More Details >>

    • No：20921
    • Release Date：2018/08/22 16:25

  • FR-A800

    No. Check the parameter setting of the A500(L), and then adjust the parameter setting of the A800 to those of the A500(L). For the details, refer to the repl... More Details >>

    • No：21108
    • Release Date：2018/08/22 16:25

  • FR-A800

    Yes, the current response is also improved at the same rate. More Details >>

    • No：21079
    • Release Date：2018/08/22 16:25

  • FR-A800-CRN

    The inverter with circuit board coating (conforming to IEC60721-3-3 3C2/3S2) ensures reliability even in poor environments. Furthermore, the inverter with pl... More Details >>

    • No：20975
    • Release Date：2018/08/22 16:25

  • FR-A800

    A separate power supply is required according to the encoder power supply specification. More Details >>

    • No：21090
    • Release Date：2018/08/22 16:25

  • FR-A800-R2R

    The calculation is performed by two modes. One method calculates the current winding diameter automatically by moving the dancer roll from lower limit positi... More Details >>

    • No：20924
    • Release Date：2018/08/22 16:25

101-110 of Total 142

Inquiries

Contact Us

page top