Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

131-140 of Total 144

prev 14 / 15page next

  • FR-A800

    Available under vector control with an encoder.* Zero speed and servo lock are available under PM sensorless vector control only in combination with an MM-CF... More Details >>

    • No：21100
    • Release Date：2018/08/22 16:25

  • MM-FR-A800

    If the command is 0.01 Hz or higher, the positioning control is performed. More Details >>

    • No：21001
    • Release Date：2018/08/22 16:25

  • FR-A800-R2R

    When the winding ratio is large, the control according to the winding diameter is required. The upper controller has measured the winding diameter and create... More Details >>

    • No：20974
    • Release Date：2018/08/22 16:25

  • FR-A800

    The FR-A800 has metal installation holes regardless of the capacity. More Details >>

    • No：20980
    • Release Date：2018/08/22 16:25

  • FR-A800-CRN

    The inverter with circuit board coating (conforming to IEC60721-3-3 3C2/3S2) ensures reliability even in poor environments. Furthermore, the inverter with pl... More Details >>

    • No：20975
    • Release Date：2018/08/22 16:25

  • FR-A800-E

    It indicate that the actual number of connectable units differs depending on the master side specification although the maximum number of connectable units o... More Details >>

    • No：20839
    • Release Date：2018/08/22 16:24

  • Switching time of the FR-A800 control

    20 ms or less is required to switch the control with the MC signal. More Details >>

    • No：20838
    • Release Date：2018/08/22 16:24

  • FR-A800

    Number of terminals: There are the same output terminals as A700 and the following terminals (2 points) are added. Safety: SO, SOC * The terminals SO and SOC... More Details >>

    • No：21098
    • Release Date：2018/08/22 16:25

  • FR-A800-R2R

    The tension PI gain can be adjusted automatically by performing the tension PI gain tuning. More Details >>

    • No：20923
    • Release Date：2018/08/22 16:25

  • Residual voltage at the output shutoff

    The rotation speed has almost no effect. The residual voltage increases when the torque boost is increased, but no adjustment is required. More Details >>

    • No：20906
    • Release Date：2018/08/22 16:25

131-140 of Total 144

Inquiries

Contact Us

page top