Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

41-50 of Total 144

prev 5 / 15page next

  • PLC function

    The processing speed, scan time, and others are slower than those of the programmable controllers. There are some restrictions in the number of I/O points, p... More Details >>

    • No：21103
    • Release Date：2018/08/22 16:25

  • FR-A800

    No. Check the parameter setting of the A500(L), and then adjust the parameter setting of the A800 to those of the A500(L). For the details, refer to the repl... More Details >>

    • No：21108
    • Release Date：2018/08/22 16:25

  • Built-in PLC function

    The error indicates that the parameter setting of the PLC function is not set. It is considered that the PC parameter is not checked when the PC parameter an... More Details >>

    • No：20859
    • Release Date：2018/08/22 16:24

  • FR-A800-E

    It is not possible because the RS-485 terminal block is not installed. Use the FR-A800 (RS-485 communication type) when performing the RS-485 communication. More Details >>

    • No：20881
    • Release Date：2018/08/22 16:24

  • FR-A800-R2R

    If Pr.361 = 0, the second terminal can be used as the line speed command when X114 is ON, and as the frequency setting value when X114 is OFF. If Pr.361 = 3,... More Details >>

    • No：20891
    • Release Date：2018/08/22 16:24

  • Emergency stop function

    The deceleration stop is also performed according to the setting in Pr.815 under V/F control. More Details >>

    • No：20957
    • Release Date：2018/08/22 16:25

  • FR-A800

    The operation panel is also compatible with the IP55 More Details >>

    • No：21091
    • Release Date：2018/08/22 16:25

  • FR Configurator2

    Vector control cannot be selected unless Pr.862 is set to 1. Only the first motor is supported in the motor setting of FR Configurator2. More Details >>

    • No：20840
    • Release Date：2018/08/22 16:24

  • Parameter copy to the USB memory

    Yes. Parameters can be read except during an inverter reset or when the password function is set. More Details >>

    • No：20961
    • Release Date：2018/08/22 16:25

  • Gain adjustment under the speed control

    Since the lower limit has been internally set, 3% or less is recognized as 3%. More Details >>

    • No：21016
    • Release Date：2018/08/22 16:25

41-50 of Total 144

Inquiries

Contact Us

page top