Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

51-60 of Total 142

prev 6 / 15page next

  • Emergency stop of the FR-A800

    For the V/F control and Advanced magnetic flux vector control, the FR-A800 stops only by Pr.1103 Deceleration time at emergency stop. Pr.815 is not affected. More Details >>

    • No：20860
    • Release Date：2018/08/22 16:24

  • FR-A800

    No. Check the parameter setting of the A500(L), and then adjust the parameter setting of the A800 to those of the A500(L). For the details, refer to the repl... More Details >>

    • No：21108
    • Release Date：2018/08/22 16:25

  • Parameter unit

    The FR-PU07(BB) can be used with some restrictions.* The major restrictions are as follows. - Pr.1000 or later cannot be set. - Alarms or warnings that are a... More Details >>

    • No：21119
    • Release Date：2018/08/22 16:26

  • Country of origin

    The country in which the product is manufactured is described on the rating plate as MADE IN JAPAN or MADE IN CHINA. More Details >>

    • No：20956
    • Release Date：2018/08/22 16:25

  • Setting resolution

    V/F control/Advanced magnetic flux vector control/Sensorless vector control: 0.3 rpm increments, Vector control with encoder: 0.1 rpm increments More Details >>

    • No：20960
    • Release Date：2018/08/22 16:25

  • FR-A800-R2R

    When the winding ratio is large, the control according to the winding diameter is required. The upper controller has measured the winding diameter and create... More Details >>

    • No：20974
    • Release Date：2018/08/22 16:25

  • FR-A800

    The FR-A800 has metal installation holes regardless of the capacity. More Details >>

    • No：20980
    • Release Date：2018/08/22 16:25

  • Vector control

    Both settings of Pr.83 and Pr.84 are enabled immediately. However, the output voltage is not changed because the value of Pr.83 has little influence on Vecto... More Details >>

    • No：21022
    • Release Date：2018/08/22 16:25

  • Trace data

    The trace data is stored in the built-in RAM of the inverter and deleted when the power is turned OFF or the inverter is reset. The data can be held with any... More Details >>

    • No：21078
    • Release Date：2018/08/22 16:25

  • CC-Link IE Field Basic

    Up to 64 (slave stations). The number of connectable units differs depending on the master station. More Details >>

    • No：20857
    • Release Date：2018/08/22 16:24

51-60 of Total 142

Inquiries

Contact Us

page top