Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

51-60 of Total 144

prev 6 / 15page next

  • FR-LU08

    Approximately 2 years when the FR-LU08 is not energized and the real-time clock function is enabled. More Details >>

    • No：21084
    • Release Date：2018/08/22 16:25

  • Use of the FR-RC

    Yes. More Details >>

    • No：21062
    • Release Date：2018/08/22 16:25

  • Model

    LD is not supported, however, SLD is supported. More Details >>

    • No：21054
    • Release Date：2018/08/22 16:25

  • PLC function

    The setting is enabled at the Y24 start-up. The frequency cannot be changed when Y24 is always ON. Turn ON Y24 when writing a frequency. More Details >>

    • No：21048
    • Release Date：2018/08/22 16:25

  • PLC function

    The maximum values are kept. The values are not cleared to zero. More Details >>

    • No：21015
    • Release Date：2018/08/22 16:25

  • FR-A800

    By performing offline auto tuning, other manufacturers' IPM, SPM motors can be used under PM sensorless vector control. * When an other manufacturers' magnet... More Details >>

    • No：21106
    • Release Date：2018/08/22 16:25

  • FR-A800

    Number of terminals: There are the same output terminals as A700 and the following terminals (2 points) are added. Safety: SO, SOC * The terminals SO and SOC... More Details >>

    • No：21098
    • Release Date：2018/08/22 16:25

  • EMC filter

    A capacitive filter and common mode choke are built in. (A common mode choke is built in only for the 55K or lower.) Use a connector for whether to turn ON o... More Details >>

    • No：21094
    • Release Date：2018/08/22 16:25

  • Trace data

    The trace data is stored in the built-in RAM of the inverter and deleted when the power is turned OFF or the inverter is reset. The data can be held with any... More Details >>

    • No：21078
    • Release Date：2018/08/22 16:25

  • Residual voltage at the output shutoff

    The rotation speed has almost no effect. The residual voltage increases when the torque boost is increased, but no adjustment is required. More Details >>

    • No：20906
    • Release Date：2018/08/22 16:25

51-60 of Total 144

Inquiries

Contact Us

page top