Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

1-10 of Total 142

prev 1 / 15page next

  • FR-A800

    The operation panel is also compatible with the IP55 More Details >>

    • No：21091
    • Release Date：2018/08/22 16:25

  • FR-A800

    By performing offline auto tuning, other manufacturers' IPM, SPM motors can be used under PM sensorless vector control. * When an other manufacturers' magnet... More Details >>

    • No：21106
    • Release Date：2018/08/22 16:25

  • FR-A800

    UVT will occur when reactor is not connected. Always connect a reactor that matches the motor capacity. More Details >>

    • No：20978
    • Release Date：2018/08/22 16:25

  • Monitoring function of the FR-A800-R2R

    No, they cannot be monitored when Pr.363 is other than "5". They are enabled only when Pr.363 = 5. More Details >>

    • No：20915
    • Release Date：2018/08/22 16:25

  • FR-A800-2

    The output turns OFF (0 mA) during the inverter reset. More Details >>

    • No：20921
    • Release Date：2018/08/22 16:25

  • Installation of a fuse

    Fuses are not required as peripheral devices for the FR-A802, which has internal fuses. More Details >>

    • No：21019
    • Release Date：2018/08/22 16:25

  • Winding diameter calculation of the FR-A800-R2R

    Z phase is not required for the thickness method. More Details >>

    • No：20855
    • Release Date：2018/08/22 16:24

  • FR-A800-R2R

    The tension PI gain can be adjusted automatically by performing the tension PI gain tuning. More Details >>

    • No：20923
    • Release Date：2018/08/22 16:25

  • FR-A800-GF/FR-A800-E

    Yes, they can. More Details >>

    • No：20856
    • Release Date：2018/08/22 16:24

  • PLC function

    When Pr.414 is set to "1" and Pr.388 is set to "0", the PLC function is not enabled unless both the SQ signal from communication and the SQ signal from the e... More Details >>

    • No：21073
    • Release Date：2018/08/22 16:25

1-10 of Total 142

Inquiries

Contact Us

page top