Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A800 ]

1-10 of Total 144

prev 1 / 15page next

  • Undervoltage warning

    The undervoltage warning of the inverter is judged based on the voltage of the main circuit as follows. Power failure only at the main circuit: Output an und... More Details >>

    • No：20853
    • Release Date：2018/08/22 16:24

  • Copy function

    No. (Using the copy function causes an error.) Use the FR-DU08 when performing the copy function of the operation panel. More Details >>

    • No：21118
    • Release Date：2018/08/22 16:26

  • SW1DND-FRC2 (FR Configurator2)

    Check the setting value of Pr.414 (PLC function operation selection) and if the initial value: 0 (PLC function disabled) is set, set "1" or "2" and enable th... More Details >>

    • No：21080
    • Release Date：2018/08/22 16:25

  • Radio Act

    The Radio Act applies to the products used for the purpose of the radio waves. Inverters are used for motor drive and thus out of the scope. More Details >>

    • No：20994
    • Release Date：2018/08/22 16:25

  • Parameter copy to the USB memory

    No. Writing is not available when the model is different. Writing the parameter copy file using a USB memory device is available only for the same models. Ot... More Details >>

    • No：21014
    • Release Date：2018/08/22 16:25

  • The lifetime of EEPROM write

    It is said that the EEPROM has a lifetime of 100,000 write cycles. When the data is written every time the frequency changes, the life of the EEPROM may not ... More Details >>

    • No：20996
    • Release Date：2018/08/22 16:25

  • Parameter copy to the USB memory

    Yes. Parameters can be read except during an inverter reset or when the password function is set. More Details >>

    • No：20961
    • Release Date：2018/08/22 16:25

  • PLC function

    The maximum values are kept. The values are not cleared to zero. More Details >>

    • No：21015
    • Release Date：2018/08/22 16:25

  • Output signal

    The length within 30 m is recommended. When the wiring length is long, signals may not be received accurately due to the increased inductance. More Details >>

    • No：20995
    • Release Date：2018/08/22 16:25

  • Storage area

    The storage areas for the sequence programs and for the parameters of the inverter are different. More Details >>

    • No：20958
    • Release Date：2018/08/22 16:25

1-10 of Total 144

Inquiries

Contact Us

page top