Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F800 ]

71-80 of Total 89

prev 8 / 9page next

  • Output signal

    The length within 30 m is recommended. When the wiring length is long, signals may not be received accurately due to the increased inductance. More Details >>

    • No：20995
    • Release Date：2018/08/22 16:25

  • FR-LU08

    Approximately 2 years when the FR-LU08 is not energized and the real-time clock function is enabled. More Details >>

    • No：21084
    • Release Date：2018/08/22 16:25

  • FR-PU07

    No. They can be connected with the connection cable (FR-CB20[]). [] indicates cable length (1 m, 3 m, 5 m). More Details >>

    • No：21081
    • Release Date：2018/08/22 16:25

  • Radio noise filter (FR-BIF)

    A radio noise filter can be used with a built-in filter. More Details >>

    • No：21113
    • Release Date：2018/08/22 16:25

  • Copy function

    No. (Using the copy function causes an error.) Use the FR-DU08 when performing the copy function of the operation panel. More Details >>

    • No：21118
    • Release Date：2018/08/22 16:26

  • Frequency search

    DC application method (Pr.162 = 0 or 10): 4 Hz or lower is regarded as 0 Hz. AC application method (Pr.162 = 3 or 13): It is not defined since it depends on ... More Details >>

    • No：20905
    • Release Date：2018/08/22 16:25

  • Parameter copy to the USB memory

    No. Writing is not available when the model is different. Writing the parameter copy file using a USB memory device is available only for the same models. Ot... More Details >>

    • No：21014
    • Release Date：2018/08/22 16:25

  • Operation mode switch of the FR-A800/F800

    When Pr.551 is set to "3" (Command right to the USB connector at the PU operation), or when the USB is connected, the operation is not switched. More Details >>

    • No：20861
    • Release Date：2018/08/22 16:24

  • SW1DND-FRC2 (FR Configurator2)

    Check the setting value of Pr.414 (PLC function operation selection) and if the initial value: 0 (PLC function disabled) is set, set "1" or "2" and enable th... More Details >>

    • No：21080
    • Release Date：2018/08/22 16:25

  • Plug-in options

    Up to three plug-in options can be mounted. More Details >>

    • No：21093
    • Release Date：2018/08/22 16:25

71-80 of Total 89

Inquiries

Contact Us

page top