Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

141-150 of Total 393

prev 15 / 40page next

  • Output current

    Increasing the value of Pr.0 (Torque boost) increases the output voltage, and the output current also increases.Note that increasing this value too high puts... More Details >>

    • No：21732
    • Release Date：2018/08/22 16:29

  • Operation method

    Set Pr.79 (Operation mode) to "3" and Pr.161 (Frequency setting/key lock operation selection) to "1". More Details >>

    • No：21249
    • Release Date：2018/08/22 16:26

  • Operation mode setting value

    Set Pr.79 to "2" (external operation mode).　　　 More Details >>

    • No：21818
    • Release Date：2018/08/22 16:29

  • PU operation

    1. Yes. 2. Set Pr.17 to "2". 　3. If the start signal is ON, the operation continues even the emergency stop is OFF. More Details >>

    • No：21359
    • Release Date：2018/08/22 16:27

  • Frequency setting

    You can use it for inverter operation, but the running speed of the inverter does not change linearly with regard to turn of the frequency setting potentiome... More Details >>

    • No：21912
    • Release Date：2018/08/22 16:30

  • Frequency setting

    Up to 30 m. (To avoid noise and voltage drop)　　 More Details >>

    • No：21910
    • Release Date：2018/08/22 16:30

  • Monitor indicator

    Press the "SET" key once while the output frequency is monitored.The unit indicator LED changes from "Hz" to "A" and the monitor display changes to the current. More Details >>

    • No：21764
    • Release Date：2018/08/22 16:29

  • Running frequency

    Check the setting of Pr.1 (Maximum frequency) and Pr.18 (High speed maximum frequency).Pr.1 is initially set to "120 Hz". More Details >>

    • No：21821
    • Release Date：2018/08/22 16:29

  • Frequency setting

    When the potentiometer is disconnected and frequency commands cease, the input potential becomes around 0 V.Therefore, the frequency command becomes analog-c... More Details >>

    • No：21794
    • Release Date：2018/08/22 16:29

  • Frequency setting

    You cannot calibrate the frequency around the middle of the current input range.The inverter determines the top and bottom points in the bias/gain adjustment... More Details >>

    • No：21736
    • Release Date：2018/08/22 16:29

141-150 of Total 393

Inquiries

Contact Us

page top