Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

161-170 of Total 393

prev 17 / 40page next

  • 10 VDC voltage from terminal 10

    Setting Pr.73 to "0" does not generate 10 VDC output.The inverter itself only has 5 V at the terminal 10.Setting this parameter to "0" allows 10 V input betw... More Details >>

    • No：21727
    • Release Date：2018/08/22 16:29

  • NET mode

    After setting Pr.340 to "10", you need to power OFF then ON the inverter to make the new setting enabled because you are setting the operation upon power-on.... More Details >>

    • No：21759
    • Release Date：2018/08/22 16:29

  • Operation panel LED

    No problem.LEDs "PU" and "EXT" indicate that Pr.79 is set to "3"."MON" indicates that the operation status is monitored."RUN" indicates that the inverter is ... More Details >>

    • No：21776
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Change Pr.161 (Frequency setting/key lock operation selection) to "1" (potentiometer mode).　　 More Details >>

    • No：21792
    • Release Date：2018/08/22 16:29

  • CC-Link

    The way to monitor the output current and read parameters via CC-Link is identical in all operation modes.　 More Details >>

    • No：21872
    • Release Date：2018/08/22 16:29

  • Frequency setting

    For the set frequency 60 Hz, ±6 Hz is applied and thus the up to frequency signal is output between 54 Hz and 66 Hz. During acceleration/deceleration to the ... More Details >>

    • No：21348
    • Release Date：2018/08/22 16:27

  • Electromagnetic contactor

    It cannot be avoided by using parameters.　　 More Details >>

    • No：21724
    • Release Date：2018/08/22 16:29

  • CC-Link

    To set the frequency via CC-Link communication, the NET mode should be selected. The new parameter setting is applied after powering OFF and then ON the inve... More Details >>

    • No：21763
    • Release Date：2018/08/22 16:29

  • CC-Link

    If you are using CC-Link just to monitor the inverter and using the analog signal and multi-speed setting to set the frequency, you need to input them extern... More Details >>

    • No：21900
    • Release Date：2018/08/22 16:29

  • CC-Link

    You can start/stop operation, set the frequency, read/write parameters, and monitor the inverter via CC-Link communication. More Details >>

    • No：21901
    • Release Date：2018/08/22 16:29

161-170 of Total 393

Inquiries

Contact Us

page top