Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

251-260 of Total 393

prev 26 / 40page next

  • Input/output voltage

    The output voltage will not be imbalanced when the inverter is used. (Since AC is converted into DC and then into AC, the output voltage is hardly effected f... More Details >>

    • No：21278
    • Release Date：2018/08/22 16:26

  • Brake resistor

    It will be the shared type. More Details >>

    • No：21331
    • Release Date：2018/08/22 16:27

  • Full scale frequency

    You can change the full-scale value by changing Pr.55 (Frequency monitor reference). The initial setting is 60 Hz. More Details >>

    • No：21672
    • Release Date：2018/08/22 16:28

  • Advanced magnetic flux vector control

    Set "13" in Pr.71. Always perform auto tuning. More Details >>

    • No：21299
    • Release Date：2018/08/22 16:26

  • Operation panel LED

    No problem.LEDs "PU" and "EXT" indicate that Pr.79 is set to "3"."MON" indicates that the operation status is monitored."RUN" indicates that the inverter is ... More Details >>

    • No：21776
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Set Pr.125 (Terminal 2 frequency setting gain frequency) = "90 Hz".This changes the frequency with the potentiometer turned to the maximum position (at 5 V i... More Details >>

    • No：21909
    • Release Date：2018/08/22 16:30

  • Motor coasting

    To set the motor to coasting state, the following methods are available: 1. Set Pr.250 (Stop selection) to "0" and turn OFF the start command. 2. Short the t... More Details >>

    • No：21271
    • Release Date：2018/08/22 16:26

  • Fault output terminal A, B, and C

    Set the rated motor current to Pr.9. It is the heat protection setting for the motor, and thus the inverter does not shutoff immediately at the specified cur... More Details >>

    • No：21324
    • Release Date：2018/08/22 16:27

  • FR-DU07

    Not possible.Instead of FR-DU07, use FR-PA07　(or FR-PU07) as an operation panel for FR-E700. More Details >>

    • No：21708
    • Release Date：2018/08/22 16:29

  • Parameter copy method of FR-Configurator

    The data can be copied to other inverters. 1. Save the parameter of the inverter to be copied with extension "pr3" by using "export". 2. Replace the connecte... More Details >>

    • No：21307
    • Release Date：2018/08/22 16:26

251-260 of Total 393

Inquiries

Contact Us

page top