Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

261-270 of Total 394

prev 27 / 40page next

  • FR-PA07

    Only the operation command source is switched to the FR-A07 and the inverter operation panel does not turn off. (Setting from the inverter operation panel be... More Details >>

    • No：21699
    • Release Date：2018/08/22 16:28

  • Auto tuning

    Normally, the auto tuning condition depends on the combination of the inverter and motor (including wiring to the motor), perform auto tuning each time. The ... More Details >>

    • No：21293
    • Release Date：2018/08/22 16:26

  • CC-Link

    Purchase the FR-A7NC if you are using the option with the FR-A700 or FR-F700P (F700).Purchase the FR-A7NC E kit if you are using the option with the FR-E700. More Details >>

    • No：21902
    • Release Date：2018/08/22 16:30

  • Model selection

    Use the FR-A740. Basically, select the capacity according to the calculation result of "rated inverter output current ? rated motor current × 1.1". More Details >>

    • No：21244
    • Release Date：2018/08/22 16:26

  • CC-Link

    If you are using CC-Link just to monitor the inverter and using the analog signal and multi-speed setting to set the frequency, you need to input them extern... More Details >>

    • No：21900
    • Release Date：2018/08/22 16:29

  • CC-Link

    "n" in the address RWwn indicates a value determined by the station number setting. More Details >>

    • No：21867
    • Release Date：2018/08/22 16:29

  • Operation panel and FR-PA07

    Since the operation panel and PU connector cannot be specified for command source at the same time, they cannot be used together. More Details >>

    • No：21349
    • Release Date：2018/08/22 16:27

  • Brake resistor

    The brake unit can be installed. FR-BU2-1.5K and GZG300W50 ? can be used in combination. More Details >>

    • No：21332
    • Release Date：2018/08/22 16:27

  • CC-Link communication

    After setting Pr.79 (Operation mode selection) to "2" and Pr.340 (Communication startup mode selection) to "10", reset the inverter (or power ON again) to st... More Details >>

    • No：21256
    • Release Date：2018/08/22 16:26

  • CC-Link

    For the inverter, the option card FR-A7NC is necessary.　　 More Details >>

    • No：21897
    • Release Date：2018/08/22 16:29

261-270 of Total 394

Inquiries

Contact Us

page top