Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

311-320 of Total 393

prev 32 / 40page next

  • CC-Link communication

    After setting Pr.79 (Operation mode selection) to "2" and Pr.340 (Communication startup mode selection) to "10", reset the inverter (or power ON again) to st... More Details >>

    • No：21256
    • Release Date：2018/08/22 16:26

  • Output signal

    The length within 30 m is recommended. When the wiring length is long, signals may not be received accurately due to the increased inductance. More Details >>

    • No：20995
    • Release Date：2018/08/22 16:25

  • CC-Link

    Did you purchase the FR-A7NC?If the front cover is supplied with the FR-A7NC E kit, it will fit. More Details >>

    • No：21895
    • Release Date：2018/08/22 16:29

  • FR-E700

    Install the DIN rail attachment to each inverter.The optional FR-A7NC is built in the inverter and does not influence installation of the inverter. More Details >>

    • No：21884
    • Release Date：2018/08/22 16:29

  • Auto tuning

    Set it to "13" (Constant-torque).　　 More Details >>

    • No：21752
    • Release Date：2018/08/22 16:29

  • 10 VDC voltage from terminal 10

    Setting Pr.73 to "0" does not generate 10 VDC output.The inverter itself only has 5 V at the terminal 10.Setting this parameter to "0" allows 10 V input betw... More Details >>

    • No：21727
    • Release Date：2018/08/22 16:29

  • Stop-on-contact control

    Set Pr.270 (Stop-on-contact control) to "1".Set Pr.184 (RES terminal function selection) to "3" to choose the RT signal function.When the terminals RL and RT... More Details >>

    • No：21691
    • Release Date：2018/08/22 16:28

  • A7AY

    1. Yes. 　2. The standard set by Pr.56. More Details >>

    • No：21669
    • Release Date：2018/08/22 16:28

  • Operation mode setting

    The stop-on-contact control does not function in the combined operation mode. 　Perform the control in the External operation mode. More Details >>

    • No：21354
    • Release Date：2018/08/22 16:27

  • Operation panel and FR-PA07

    Since the operation panel and PU connector cannot be specified for command source at the same time, they cannot be used together. More Details >>

    • No：21349
    • Release Date：2018/08/22 16:27

311-320 of Total 393

Inquiries

Contact Us

page top