Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

321-330 of Total 394

prev 33 / 40page next

  • Switching between PU and NET operation modes

    Set Pr.340 (Communication startup mode selection) to "10".The operation mode can be switched between PU and NET by assigning X65 (PU-NET operation switching)... More Details >>

    • No：21878
    • Release Date：2018/08/22 16:29

  • Frequency setting

    No. Use a frequency setting potentiometer with the resistance of 1 kΩ and B characteristics.Input voltage is not linear due to the inverter's internal impeda... More Details >>

    • No：21911
    • Release Date：2018/08/22 16:30

  • Frequency setting

    You can use it for inverter operation, but the running speed of the inverter does not change linearly with regard to turn of the frequency setting potentiome... More Details >>

    • No：21912
    • Release Date：2018/08/22 16:30

  • FR-PU04

    While the FR-PU04 does not display parameter names, it displays parameter numbers and you can set them. More Details >>

    • No：21919
    • Release Date：2018/08/22 16:30

  • FR-E700KNC

    The inverter is reset. More Details >>

    • No：20869
    • Release Date：2018/08/22 16:24

  • Radio Act

    The Radio Act applies to the products used for the purpose of the radio waves. Inverters are used for motor drive and thus out of the scope. More Details >>

    • No：20994
    • Release Date：2018/08/22 16:25

  • Multi-speed setting

    If Pr 27 is not set, the operation starts at the speed of RL. More Details >>

    • No：21123
    • Release Date：2018/08/22 16:26

  • Frequency setting signal

    Check the AU signal (AU - SD). To use the terminal 4, the AU signal (AU - SD) needs to be turned ON. Turning ON the AU signal (AU - SD) disables the terminal 2. More Details >>

    • No：21267
    • Release Date：2018/08/22 16:26

  • Speed command

    Calibrate the terminal 2 bias. More Details >>

    • No：21281
    • Release Date：2018/08/22 16:26

  • Advanced magnetic flux vector control and General-purpose magnetic flux vector control

    Advanced magnetic flux vector control provides a larger torque at low-speed. 3.7K or lower: 0.5 Hz/200%5.5K to 15K: 0.5 Hz/150% More Details >>

    • No：21297
    • Release Date：2018/08/22 16:26

321-330 of Total 394

Inquiries

Contact Us

page top