Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ FREQROL-E700 ]

361-370 of Total 394

prev 37 / 40page next
  • USB connector

    The USB connection requires FR Configurator (FR-SW3-SETUP-WJ) prepared by Mitsubishi Electric Corporation. More Details >>

    • No:21318
    • Release Date:2018/08/22 16:27
  • Noise filter

    The noise filter is not built-in the FR-E700 series. It is built in the FR-A700/F700 series with the 55K or lower capacity. More Details >>

    • No:21276
    • Release Date:2018/08/22 16:26
  • Brake unit

    The brake unit operates when the bus voltage exceeds the brake operation voltage. More Details >>

    • No:21272
    • Release Date:2018/08/22 16:26
  • FR-PA02 built-in potentiometer

    Change Pr.146 (Built-in potentiometer switching) to "0" (built-in frequency setting potentiometer). More Details >>

    • No:21862
    • Release Date:2018/08/22 16:29
  • Parameter setting

    Check if Pr.13 (Starting frequency) is set to higher than 10 Hz.Also check if a signal is input through the terminal MRS. More Details >>

    • No:21722
    • Release Date:2018/08/22 16:29
  • RS-485 communication

    It is available since June, 2007. The model is FR-E7TR. More Details >>

    • No:21300
    • Release Date:2018/08/22 16:26
  • FR-E720

    The following is the amount of heat generated for each capacity:0.1K: 14W  0.2K: 20W  0.4K: 32W  0.75K: 50W1.5K: 80W  2.2K: 100W  3.7K: 160W  5.5K: 290W7.5K:... More Details >>

    • No:21706
    • Release Date:2018/08/22 16:29
  • FR-E710W

    Yes. The model is FR-E710W. The input is single-phase 100 V, but the output is three-phase 200 V. More Details >>

    • No:21320
    • Release Date:2018/08/22 16:27
  • FR-E720S-NC

    They are not insulated. More Details >>

    • No:21182
    • Release Date:2018/08/22 16:26
  • FR-E720S-KNC

    It is available on request. More Details >>

    • No:21164
    • Release Date:2018/08/22 16:26

361-370 of Total 394

Inquiries