Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

371-380 of Total 394

prev 38 / 40page next

  • PU operation

    Set Pr.79 (Operation mode) to "1" (PU operation mode) and change Pr.161 (Frequency setting/key lock operation selection) to "1" (potentiometer mode).　　 More Details >>

    • No：21863
    • Release Date：2018/08/22 16:29

  • Control terminal

    Yes. (Terminal SDs are connected with each other inside of the inverter.) More Details >>

    • No：21845
    • Release Date：2018/08/22 16:29

  • Frequency setting

    When the frequency is set using the setting dial, it is not necessary to set it again.The inverter memorizes the setting value internally even after the powe... More Details >>

    • No：21842
    • Release Date：2018/08/22 16:29

  • CC-Link

    By attaching the optional card and dedicated cover, the depth increases by approximately 15 mm for the FR-E700, and approximately 22 mm for the FR-E700-SC.Si... More Details >>

    • No：21835
    • Release Date：2018/08/22 16:29

  • Operation mode setting value

    Set Pr.79 to "2" (external operation mode).　　　 More Details >>

    • No：21818
    • Release Date：2018/08/22 16:29

  • External terminal

    1. Use the external terminals STF, RL, and SD. (A push-ON switch for operation is required between the terminals STF and SD, and a push-OFF switch is require... More Details >>

    • No：21816
    • Release Date：2018/08/22 16:29

  • Current setting

    Yes.The parameters used when the terminal 4 is used are C5, C6, 126, and C7.Set Pr.C5 (Terminal 4 frequency setting bias frequency) while feeding a current s... More Details >>

    • No：21770
    • Release Date：2018/08/22 16:29

  • Frequency setting

    No. You cannot change the setting during operation.However, setting Pr.77 (Parameter write selection) to "2" allows for the setting change during operation. ... More Details >>

    • No：21734
    • Release Date：2018/08/22 16:29

  • FR-E740

    The following is the amount of heat generated for each capacity:0.4K: 40W　　0.75K: 55W　　1.5K: 90W　　2.2K: 100W3.7K: 180W　　5.5K: 240W　　7.5K: 300W　　11K: 400W15K:... More Details >>

    • No：21705
    • Release Date：2018/08/22 16:29

  • Connecting ammeter to output side

    Yes. Use a moving-iron type ammeter. However, if the carrier frequency exceeds 5 kHz, do not use that meter since an overcurrent losses produced in the inter... More Details >>

    • No：21681
    • Release Date：2018/08/22 16:28

371-380 of Total 394

Inquiries

Contact Us

page top