Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

31-40 of Total 394

prev 4 / 40page next

  • CC-Link

    Yes, but the optional kit (FR-A7NC E kit) is necessary. More Details >>

    • No：21877
    • Release Date：2018/08/22 16:29

  • Wiring and terminal

    The ferrule terminal or single wire can be used for the control circuit wiring. More Details >>

    • No：21275
    • Release Date：2018/08/22 16:26

  • Advanced magnetic flux vector control

    Set "13" in Pr.71. Always perform auto tuning. More Details >>

    • No：21299
    • Release Date：2018/08/22 16:26

  • Operation mode setting

    The stop-on-contact control does not function in the combined operation mode. 　Perform the control in the External operation mode. More Details >>

    • No：21354
    • Release Date：2018/08/22 16:27

  • Stop-on-contact control

    Set Pr.270 (Stop-on-contact control) to "1".Set Pr.184 (RES terminal function selection) to "3" to choose the RT signal function.When the terminals RL and RT... More Details >>

    • No：21691
    • Release Date：2018/08/22 16:28

  • Auto tuning

    When offline auto tuning ends normally, the setting of this parameter changes to "3".This means that auto tuning completed normally.If the setting value is "... More Details >>

    • No：21748
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Since the Advanced magnetic flux vector control method uses slip compensation to compensate the frequency, the value is not shown as exactly 60 Hz.For V/F co... More Details >>

    • No：21807
    • Release Date：2018/08/22 16:29

  • FR-E700-SC

    Not available for the FR-E700-SC. For the 485 communication with the terminal block, use the standard FR-E700. More Details >>

    • No：21130
    • Release Date：2018/08/22 16:26

  • Advanced magnetic flux vector control

    Check the parameters necessary for tuning again.Check if Pr.9 (Electronic thermal O/L relay) and Pr.81 (Number of motor poles) are set correctly. More Details >>

    • No：21754
    • Release Date：2018/08/22 16:29

  • Output frequency monitor value

    When running the inverter after auto tuning, the frequency setting value is increased by the amount of the motor slippage, resulting in a higher monitor valu... More Details >>

    • No：21781
    • Release Date：2018/08/22 16:29

31-40 of Total 394

Inquiries

Contact Us

page top