It is not stored in a parameter but memorized as the frequency setting value after acceleration by the acceleration signal.You can also choose whether or not... More Details >>
The FR-E720S series and D720S series conform to the single-phase 200 V input specifications. More Details >>
Check if Pr.13 (Starting frequency) is set to higher than 10 Hz.Also check if a signal is input through the terminal MRS. More Details >>
Yes.Set Pr.19 (Base frequency voltage) to "200 V".200 V output will be obtained during 60 Hz operation. More Details >>
No. You cannot check the accumulated number of rotations on the monitor. More Details >>
Yes, you can use the setup software (FR-SW3-SETUP-WJ) to set it. More Details >>
Set Pr.270 (Stop-on-contact control) to "1".Set Pr.184 (RES terminal function selection) to "3" to choose the RT signal function.When the terminals RL and RT... More Details >>
Use Pr.903 (Frequency setting voltage gain) for setting the FR-E500. For the 700 series, use Pr.125 (Terminal 2 frequency setting gain frequency) and Pr.C4 (... More Details >>
Switching between external operation ...
You can write frequency setting by setting Pr.339 (Communication speed command source) to "0". More Details >>
Yes, you can set Pr.20 to 20 Hz. More Details >>
51-60 of Total 394