Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-D700 ]

181-190 of Total 260

prev 19 / 26page next

  • Frequency setting signal

    Set C5 (Pr.904) (Terminal 4 frequency setting bias frequency) to 0 Hz and Pr.126 (Terminal 4 frequency setting gain frequency) to 50 Hz. More Details >>

    • No：21268
    • Release Date：2018/08/22 16:26

  • Electromagnetic contactor

    It is not recommended to start and stop the inverter with the electromagnetic contactor (MC). This will accelerate the deterioration (due to the inrush curre... More Details >>

    • No：21322
    • Release Date：2018/08/22 16:27

  • Multi-speed setting

    Priorities are: Low speed (RL) > Middle speed (RM) > High speed (RH).For example, if the low speed (RL) and middle speed (RM) signals are input simulta... More Details >>

    • No：21772
    • Release Date：2018/08/22 16:29

  • Frequency setting

    You can change the terminal 4 to voltage input. (The terminal 4 is set to the current input terminal at the initial setting.)To change the terminal 4 to volt... More Details >>

    • No：21787
    • Release Date：2018/08/22 16:29

  • Operation stop, frequency setting

    Set Pr.79 (Operation mode) to "1" (PU operation mode).　 More Details >>

    • No：21819
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Up to 30 m. (To avoid noise and voltage drop)　　 More Details >>

    • No：21910
    • Release Date：2018/08/22 16:30

  • FR-PA07

    Specific settings are not required, however, when replacing the FR-E500, check that Pr.146 (Built-in potentiometer switchover) is not set to "0". If it is "0... More Details >>

    • No：21363
    • Release Date：2018/08/22 16:27

  • Frequency setting

    Pr.1 (Maximum frequency) and Pr.18 (Maximum frequency).　　 More Details >>

    • No：21744
    • Release Date：2018/08/22 16:29

  • Parameter setting

    Yes. The single-phase 200 V can be input. If the single-phase input is performed when Pr.872 (Input phase loss protection) is set to "1", the input phase los... More Details >>

    • No：21270
    • Release Date：2018/08/22 16:26

  • Cooling fan

    Pr.244 (Cooling fan operation selection) controls turning ON/OFF of the cooling fan and is initially set to "1". When the inverter is powered ON, the cooling... More Details >>

    • No：21670
    • Release Date：2018/08/22 16:28

181-190 of Total 260

Inquiries

Contact Us

page top