Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-D700 ]

231-240 of Total 260

prev 24 / 26page next

  • Amount of heat generated

    Refer to the FR-A700/F700/E700/D700 series TECHNICAL MANUAL (section 3.7.2) and the Technical News. The FR-A700/F700/E700/D700 series TECHNICAL MANUAL can be... More Details >>

    • No：21263
    • Release Date：2018/08/22 16:26

  • Output frequency

    When Pr.80 and Pr.81 are set to the value other than "9999", control other than V/F control is performed. For the FR-F700(P) FR-D700, and FR-F700PJ, Pr.81 is... More Details >>

    • No：21259
    • Release Date：2018/08/22 16:26

  • Frequency setting

    Use Pr.125 (Terminal 2 frequency setting gain frequency).　 More Details >>

    • No：21913
    • Release Date：2018/08/22 16:30

  • Frequency

    It seems that calibration for 20 mA current signal input is not correct.Use the calibration parameters "126" and "C7" to calibrate the inverter.Perform calib... More Details >>

    • No：21785
    • Release Date：2018/08/22 16:29

  • Setting frequency

    Set Pr.52 (DU/PU main display data selection) to "100".Displaying the setting frequency while the inverter is stopped and the output frequency while it is op... More Details >>

    • No：21783
    • Release Date：2018/08/22 16:29

  • Frequency monitor window

    When both "Hz" and "A" are turned off, the output voltage monitor is active.The display indicates that the output voltage is 19.5 V. More Details >>

    • No：21782
    • Release Date：2018/08/22 16:29

  • Output current value

    The detection level of the output current value cannot be changed using a potentiometer or a similar device.　　 More Details >>

    • No：21779
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Since the percent value read by the calibration parameter C7 indicates that the voltage of 10 V is internally detected as 101.0%, use 101.0% as is.If you cha... More Details >>

    • No：21740
    • Release Date：2018/08/22 16:29

  • Frequency setting

    It is not stored in a parameter but memorized as the frequency setting value after acceleration by the acceleration signal.You can also choose whether or not... More Details >>

    • No：21733
    • Release Date：2018/08/22 16:29

  • Parameter setting

    You can perform forward and reverse operations with the RUN key on the operation panel by setting Pr.40 (RUN key rotation direction selection). More Details >>

    • No：21719
    • Release Date：2018/08/22 16:29

231-240 of Total 260

Inquiries

Contact Us

page top