It is not switched. The frequency at the fault saved in the faults history is always displayed in frequency [Hz].

Set Pr.79 (Operation mode) to "3" and Pr.161 (Frequency setting/key lock operation selection) to "1".

The station numbers that can be set differ depending on the version of FR-Configurator (FR-SW3-SETUP-WJ) setup software.

Connect the brake resistor to the terminal P and terminal PR. (For the FR-A700-7.5K or lower, remove the jumper of the t

Specific settings are not required, however, when replacing the FR-E500, check that Pr.146 (Built-in potentiometer switc

Operations cannot be enabled separately. You only can disable or enable all the operations.

1. Yes. 2. The standard set by Pr.56.

Connecting it causes no problem.

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Drive Products > Inverters-FREQROL > FREQROL-D700

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

FAQ within [ FREQROL-D700 ]

1-10 of Total 261

prev 1 / 27page next

Rotation speed display

It is not switched. The frequency at the fault saved in the faults history is always displayed in frequency [Hz]. More Details >>
- No：21180
- Release Date：2018/08/22 16:26
Operation method

Set Pr.79 (Operation mode) to "3" and Pr.161 (Frequency setting/key lock operation selection) to "1". More Details >>
- No：21249
- Release Date：2018/08/22 16:26
Driving a single-phase motor

No, it cannot. More Details >>
- No：21253
- Release Date：2018/08/22 16:26
Number of stations that can be set in FR Configurator

The station numbers that can be set differ depending on the version of FR-Configurator (FR-SW3-SETUP-WJ) setup software. For Ver.2.00 or later, station numbe... More Details >>
- No：21305
- Release Date：2018/08/22 16:26
Brake resistor

It will be the shared type. More Details >>
- No：21331
- Release Date：2018/08/22 16:27
Brake resistor

Connect the brake resistor to the terminal P and terminal PR. (For the FR-A700-7.5K or lower, remove the jumper of the terminals PR and PX.) Do not remove th... More Details >>
- No：21333
- Release Date：2018/08/22 16:27
FR-PA07

Specific settings are not required, however, when replacing the FR-E500, check that Pr.146 (Built-in potentiometer switchover) is not set to "0". If it is "0... More Details >>
- No：21363
- Release Date：2018/08/22 16:27
FR-PA07

Operations cannot be enabled separately. You only can disable or enable all the operations. More Details >>
- No：21366
- Release Date：2018/08/22 16:27
A7AY

1. Yes. 　2. The standard set by Pr.56. More Details >>
- No：21669
- Release Date：2018/08/22 16:28
Motor with an attached brake

Connecting it causes no problem. More Details >>
- No：21671
- Release Date：2018/08/22 16:28

1-10 of Total 261

Inquiries

page top