Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

111-120 of Total 352

prev 12 / 36page next

  • CC-Link station number setting

    Change the setting in the PU operation mode.　　 More Details >>

    • No：21747
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Pr.1 (Maximum frequency) and Pr.18 (Maximum frequency).　　 More Details >>

    • No：21744
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Even while the inverter is operating, you can use the setting dial to change the frequency and then press the SET key and the inverter operates at the new fr... More Details >>

    • No：21739
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Change the value of Pr.18 (High speed maximum frequency).You can set any frequency within the range defined by Pr.18. More Details >>

    • No：21737
    • Release Date：2018/08/22 16:29

  • Frequency setting

    You cannot calibrate the frequency around the middle of the current input range.The inverter determines the top and bottom points in the bias/gain adjustment... More Details >>

    • No：21736
    • Release Date：2018/08/22 16:29

  • Frequency setting

    No. You cannot change the setting during operation.However, setting Pr.77 (Parameter write selection) to "2" allows for the setting change during operation. ... More Details >>

    • No：21734
    • Release Date：2018/08/22 16:29

  • Automatic restart after instantaneous power failure setting

    You also need to set Pr.57 (Restart coasting time).The function does not work just by setting Pr.162 unless setting this parameter.(For A700, F700, and F700P... More Details >>

    • No：21731
    • Release Date：2018/08/22 16:29

  • Speed setting

    Use the inverter's calibration parameters Pr.C2/C3, Pr.125/C4 to adjust the bias and gain for each inverter.Connect the wires from the frequency setting pote... More Details >>

    • No：21728
    • Release Date：2018/08/22 16:29

  • 10 VDC voltage from terminal 10

    Setting Pr.73 to "0" does not generate 10 VDC output.The inverter itself only has 5 V at the terminal 10.Setting this parameter to "0" allows 10 V input betw... More Details >>

    • No：21727
    • Release Date：2018/08/22 16:29

  • Electromagnetic contactor

    Turning ON/OFF the output side during operation causes open/close surges that may trigger the protective function (against overcurrent or overvoltage) of the... More Details >>

    • No：21725
    • Release Date：2018/08/22 16:29

111-120 of Total 352

Inquiries

Contact Us

page top