Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

171-180 of Total 351

prev 18 / 36page next

  • Operation panel

    This is because the protective function works to stop the motor. It is not a fault indication.To cancel the protective function, turn OFF the start signal an... More Details >>

    • No：21775
    • Release Date：2018/08/22 16:29

  • Terminal FM meter connection

    Check the connection with the meter.If the terminal FM is connected to the positive terminal and the terminal SD is connected to the negative terminal of the... More Details >>

    • No：21762
    • Release Date：2018/08/22 16:29

  • Frequency setting

    This parameter cannot be changed in the external operation mode.Change Pr.77 (Parameter write selection) to "2" before changing the setting of Pr.72. More Details >>

    • No：21743
    • Release Date：2018/08/22 16:29

  • FR-PA07

    Specific settings are not required, however, when replacing the FR-E500, check that Pr.146 (Built-in potentiometer switchover) is not set to "0". If it is "0... More Details >>

    • No：21363
    • Release Date：2018/08/22 16:27

  • Model setting in FR-Configurator

    Check the version of FR-Configurator (FR-SW3-SETUP-WJ). If the version is "1.00", it does not support or detect the FR-E740. Version "2.00" supports the FR-E... More Details >>

    • No：21309
    • Release Date：2018/08/22 16:26

  • Input phase loss

    The detection time 1 s cannot be changed. More Details >>

    • No：21277
    • Release Date：2018/08/22 16:26

  • Multi-speed setting

    If Pr 27 is not set, the operation starts at the speed of RL. More Details >>

    • No：21123
    • Release Date：2018/08/22 16:26

  • Frequency setting

    Since Pr.125 (Terminal 2 frequency setting gain frequency) is initially set to 60 Hz, change it to 85 Hz. More Details >>

    • No：21907
    • Release Date：2018/08/22 16:30

  • CC-Link

    Set Pr.340 (Communication startup mode selection) to other than "0".Also, set Pr.79 (Operation mode) to "0", "2", or "6".Powering the inverter on automatical... More Details >>

    • No：21903
    • Release Date：2018/08/22 16:30

  • CC-Link

    Yes. More Details >>

    • No：21871
    • Release Date：2018/08/22 16:29

171-180 of Total 351

Inquiries

Contact Us

page top