Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

11-20 of Total 352

prev 2 / 36page next

  • Motor with an attached brake

    Connecting it causes no problem. More Details >>

    • No：21671
    • Release Date：2018/08/22 16:28

  • Network operation

    Yes. With the setting "66", you can choose NET operation when X66 is ON, and external operation when X66 is OFF. More Details >>

    • No：21675
    • Release Date：2018/08/22 16:28

  • Terminal

    Change Pr.126 (Terminal 4 frequency setting gain frequency). More Details >>

    • No：21677
    • Release Date：2018/08/22 16:28

  • Frequency setting

    Since Advanced magnetic flux vector control is chosen, the inverter calculates how much the motor rotation slips from the flowing current and adds the slip a... More Details >>

    • No：21684
    • Release Date：2018/08/22 16:28

  • CC-Link station number setting

    Change the setting in the PU operation mode.　　 More Details >>

    • No：21747
    • Release Date：2018/08/22 16:29

  • Frequency setting

    When the potentiometer is disconnected and frequency commands cease, the input potential becomes around 0 V.Therefore, the frequency command becomes analog-c... More Details >>

    • No：21794
    • Release Date：2018/08/22 16:29

  • Frequency setting

    To accept the current signal, the terminals AU (current input selection) and SD must be short-circuited. Check it.Note that this terminal AU is not prepared ... More Details >>

    • No：21799
    • Release Date：2018/08/22 16:29

  • Magnetic flux vector control

    For low-speed operation, perform auto tuning and use (Advanced) magnetic flux vector control. More Details >>

    • No：21810
    • Release Date：2018/08/22 16:29

  • External installationRated current

    Since the external thermal prevents the motor from being overheated, install it between the output terminal of the inverter and the motor.The rated current i... More Details >>

    • No：21817
    • Release Date：2018/08/22 16:29

  • CC-Link

    Yes. Set the first monitor code in the lower 8 bits and the second monitor code in the upper 8 bits of RWwn.Set H6F to the first monitor code, and H70 to the... More Details >>

    • No：21824
    • Release Date：2018/08/22 16:29

11-20 of Total 352

Inquiries

Contact Us

page top