Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

241-250 of Total 351

prev 25 / 36page next

  • Electromagnetic contactor

    It cannot be avoided by using parameters.　　 More Details >>

    • No：21724
    • Release Date：2018/08/22 16:29

  • Offline auto tuning

    Auto tuning can be performed because the motor is one rank lower than the inverter capacity. More Details >>

    • No：21351
    • Release Date：2018/08/22 16:27

  • Connection cable of FR-Configurator

    It is the standardized Mini-B connector. More Details >>

    • No：21312
    • Release Date：2018/08/22 16:26

  • CC-Link

    "n" in the address RWwn indicates a value determined by the station number setting. More Details >>

    • No：21867
    • Release Date：2018/08/22 16:29

  • CC-Link

    You can use the CC-Link type programming example for the FR-E500 as a reference.In the programming example for the FR-E500, the A series programmable control... More Details >>

    • No：21836
    • Release Date：2018/08/22 16:29

  • CC-Link

    Check if the master station uses CC-Link Version 1 and the FR-A7NC uses CC-Link Version 2. More Details >>

    • No：21831
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Pr.1 (Maximum frequency) or Pr.18 (High speed maximum frequency).　　 More Details >>

    • No：21805
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Yes.The inverter requires the start signal and frequency setting signal. More Details >>

    • No：21793
    • Release Date：2018/08/22 16:29

  • CC-Link

    To set the frequency via CC-Link communication, the NET mode should be selected. The new parameter setting is applied after powering OFF and then ON the inve... More Details >>

    • No：21763
    • Release Date：2018/08/22 16:29

  • 10 VDC voltage from terminal 10

    Setting Pr.73 to "0" does not generate 10 VDC output.The inverter itself only has 5 V at the terminal 10.Setting this parameter to "0" allows 10 V input betw... More Details >>

    • No：21727
    • Release Date：2018/08/22 16:29

241-250 of Total 351

Inquiries

Contact Us

page top