Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

21-30 of Total 352

prev 3 / 36page next

  • Automatic restart after instantaneous power failure

    The inverter restart operation is disabled at turn-OFF of the CS signal while a value other than "9999" (with restart) is set in Pr.57. The terminals CS and ... More Details >>

    • No：21255
    • Release Date：2018/08/22 16:26

  • Real sensorless vector control

    For tuning of a single motor with no load, set Pr.96 to "101". When a load is connected, set Pr.96 to "1" (without motor rotation). Since Real sensorless vec... More Details >>

    • No：21325
    • Release Date：2018/08/22 16:27

  • Output frequency monitor value

    When running the inverter after auto tuning, the frequency setting value is increased by the amount of the motor slippage, resulting in a higher monitor valu... More Details >>

    • No：21781
    • Release Date：2018/08/22 16:29

  • FR-A800

    No. Check the parameter setting of the A700, and then adjust the parameter setting of the A800 to those of the A700. For the details, refer to the replacemen... More Details >>

    • No：21107
    • Release Date：2018/08/22 16:25

  • Advanced magnetic flux vector control

    Check the parameters necessary for tuning again.Check if Pr.9 (Electronic thermal O/L relay) and Pr.81 (Number of motor poles) are set correctly. More Details >>

    • No：21754
    • Release Date：2018/08/22 16:29

  • Brake sequence function

    Turn OFF the BOF signal when switching the operation from forward rotation to reverse rotation. More Details >>

    • No：21184
    • Release Date：2018/08/22 16:26

  • Operation mode setting

    The stop-on-contact control does not function in the combined operation mode. 　Perform the control in the External operation mode. More Details >>

    • No：21354
    • Release Date：2018/08/22 16:27

  • Frequency setting

    Since the Advanced magnetic flux vector control method uses slip compensation to compensate the frequency, the value is not shown as exactly 60 Hz.For V/F co... More Details >>

    • No：21807
    • Release Date：2018/08/22 16:29

  • FR-A701

    It is protected not by observing the temperature directly, but by estimating it from the current value, output frequency, and carrier frequency. More Details >>

    • No：20871
    • Release Date：2018/08/22 16:24

  • Brake sequence function

    The value of Pr.20 (Acceleration/deceleration standard frequency) is corresponding to 1 s. (Initial value: 60 Hz) More Details >>

    • No：21185
    • Release Date：2018/08/22 16:26

21-30 of Total 352

Inquiries

Contact Us

page top