Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

331-340 of Total 351

prev 34 / 36page next

  • Brake unit

    The brake unit operates when the bus voltage exceeds the brake operation voltage. More Details >>

    • No：21272
    • Release Date：2018/08/22 16:26

  • Brake sequence function

    Turn OFF the BOF signal when switching the operation from forward rotation to reverse rotation. More Details >>

    • No：21184
    • Release Date：2018/08/22 16:26

  • Orientation control

    The following reasons are possible. - The signal of Z phase does not exist. (It is not returned normally.) - The setting of Pr.359 encoder rotation direction... More Details >>

    • No：21162
    • Release Date：2018/08/22 16:26

  • Frequency setting

    When running the inverter in Advanced magnetic flux vector control, the frequency setting value is increased by the amount of the motor's slippage, resulting... More Details >>

    • No：21801
    • Release Date：2018/08/22 16:29

  • Tuning

    Check the parameters listed below necessary for tuning again.Pr.9, Pr.71, Pr.80, Pr.81, Pr.83, Pr.84, and Pr.96 More Details >>

    • No：21726
    • Release Date：2018/08/22 16:29

  • Input phase loss protection

    The initial value of Pr.872 is set to "1" (Valid) because the A701 have regeneration unit built-in and an overvoltage may occur when the regenerative operati... More Details >>

    • No：20945
    • Release Date：2018/08/22 16:25

  • Connection cable of FR-Configurator

    The following USB connectors are available.For FR-A700: USB B connector (B receptacle)For FR-E700: USB Mini-B connector (Mini-B receptacle) Use the USB cable... More Details >>

    • No：21317
    • Release Date：2018/08/22 16:27

  • Auto tuning

    Set it to "13" (Constant-torque).　　 More Details >>

    • No：21752
    • Release Date：2018/08/22 16:29

  • Auto tuning

    Yes. More Details >>

    • No：21749
    • Release Date：2018/08/22 16:29

  • Vector control

    "E.OSD" occurs when the rotation speed is not decreased for one second despite the start command (STF, STR) is turned OFF. More Details >>

    • No：21159
    • Release Date：2018/08/22 16:26

331-340 of Total 351

Inquiries

Contact Us

page top