Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

1-10 of Total 351

prev 1 / 36page next

  • Wiring length

    Under Real sensorless vector control, the maximum wiring length is 500 m. Under Vector control with encoder, the maximum wiring length is 100 m. More Details >>

    • No：21133
    • Release Date：2018/08/22 16:26

  • Auto tuning

    Set "33" or "34". More Details >>

    • No：21167
    • Release Date：2018/08/22 16:26

  • Vector control

    Install the resistor between the terminals PC and OH. More Details >>

    • No：21160
    • Release Date：2018/08/22 16:26

  • Orientation control

    The following reasons are possible. - The signal of Z phase does not exist. (It is not returned normally.) - The setting of Pr.359 encoder rotation direction... More Details >>

    • No：21162
    • Release Date：2018/08/22 16:26

  • FR-A701

    It is protected not by observing the temperature directly, but by estimating it from the current value, output frequency, and carrier frequency. More Details >>

    • No：20871
    • Release Date：2018/08/22 16:24

  • Real sensorless vector control

    The FR-A700 supports Real sensorless vector control.　　 More Details >>

    • No：21714
    • Release Date：2018/08/22 16:29

  • Brake resistor

    When the built-in brake resistor is used, the regenerative brake duty is as follows:200 V 0.4K to 3.7K: 3%, 5.5K to 7.5K: 2%400 V 0.4K to 7.5K: 2 % The capac... More Details >>

    • No：21273
    • Release Date：2018/08/22 16:26

  • Vector control

    They are not output while the motor is coasting even under Vector control. More Details >>

    • No：21158
    • Release Date：2018/08/22 16:26

  • Vector control

    "E.OSD" occurs when the rotation speed is not decreased for one second despite the start command (STF, STR) is turned OFF. More Details >>

    • No：21159
    • Release Date：2018/08/22 16:26

  • Operation mode setting

    The stop-on-contact control does not function in the combined operation mode. 　Perform the control in the External operation mode. More Details >>

    • No：21354
    • Release Date：2018/08/22 16:27

1-10 of Total 351

Inquiries

Contact Us

page top