Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700 ]

91-100 of Total 295

prev 10 / 30page next

  • CC-Link

    No problem. The inverter actually occupies the reserved bits and does not use them. More Details >>

    • No：21890
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Up to 30 m. (To avoid noise and voltage drop)　　 More Details >>

    • No：21910
    • Release Date：2018/08/22 16:30

  • FR-PA07

    When Pr.79 is set to "3", since the start command is in the External operation mode, the RUN key of FR-PA07 does not work. More Details >>

    • No：21303
    • Release Date：2018/08/22 16:26

  • Parameter

    Press the "MODE" key on the operation panel several times to display "P.0" and parameter setting screen. Then turn the setting dial to display "C..." screen ... More Details >>

    • No：21336
    • Release Date：2018/08/22 16:27

  • Switching between external operation and NET operation

    You can monitor the fault output in both NET operation and external operation. More Details >>

    • No：21686
    • Release Date：2018/08/22 16:28

  • Frequency setting

    No. You cannot change the setting during operation.However, setting Pr.77 (Parameter write selection) to "2" allows for the setting change during operation. ... More Details >>

    • No：21734
    • Release Date：2018/08/22 16:29

  • Frequency setting

    You cannot calibrate the frequency around the middle of the current input range.The inverter determines the top and bottom points in the bias/gain adjustment... More Details >>

    • No：21736
    • Release Date：2018/08/22 16:29

  • CC-Link

    "n" in the address RWwn indicates a value determined by the station number setting. More Details >>

    • No：21867
    • Release Date：2018/08/22 16:29

  • CC-Link

    You can select deceleration stop by setting Pr.502 (Stop mode selection at communication error). (Select from coasting to stop, deceleration to stop, and con... More Details >>

    • No：21892
    • Release Date：2018/08/22 16:29

  • CC-Link

    For the inverter, the option card FR-A7NC is necessary.　　 More Details >>

    • No：21897
    • Release Date：2018/08/22 16:29

91-100 of Total 295

Inquiries

Contact Us

page top