You can monitor the fault output in both NET operation and external operation.

If "HOLD" is displayed, the key lock mode enabled. Press the "MODE" key for two seconds. Then, change the setting of Pr.

You also need to set Pr.79 (Operation mode) to "3".

Yes, you can use the setup software (FR-SW3-SETUP-WJ) to set it.

Yes. Use a moving-iron type ammeter. However, if the carrier frequency exceeds 5 kHz, do not use that meter since an ove

Set Pr.338 to "0" (NET) and Pr.339 to "1" or "2".

As described in the instruction manual, use the shielded cable or twisted cable to avoid the influence of noises.

Select the inverter capacity so that the rated output current of inverter ? rated motor current × 1.1.

Up to 30 m. (To avoid noise and voltage drop)

The full scale of the frequency is initially set to 60 Hz and the frequency indication becomes the full scale at 60 Hz o

FAQ

FAQAbout Products

Font Size
S
M
L

FAQ > Drive Products > Inverters-FREQROL > FREQROL-F700

FAQ

Inquiries

Keyword Search

You can search two or more words separated by a space.

 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

Result Type

Text Search

FAQ within [ FREQROL-F700 ]

141-150 of Total 295

prev 15 / 30page next

Switching between external operation and NET operation

You can monitor the fault output in both NET operation and external operation. More Details >>
- No：21686
- Release Date：2018/08/22 16:28
Easy setting mode

If "HOLD" is displayed, the key lock mode enabled. Press the "MODE" key for two seconds. Then, change the setting of Pr.79 to "1". More Details >>
- No：21350
- Release Date：2018/08/22 16:27
Control terminal

You also need to set Pr.79 (Operation mode) to "3". More Details >>
- No：21844
- Release Date：2018/08/22 16:29
FR-Configurator

Yes, you can use the setup software (FR-SW3-SETUP-WJ) to set it.　　 More Details >>
- No：21711
- Release Date：2018/08/22 16:29
Connecting ammeter to output side

Yes. Use a moving-iron type ammeter. However, if the carrier frequency exceeds 5 kHz, do not use that meter since an overcurrent losses produced in the inter... More Details >>
- No：21681
- Release Date：2018/08/22 16:28
Network operation

Set Pr.338 to "0" (NET) and Pr.339 to "1" or "2". More Details >>
- No：21674
- Release Date：2018/08/22 16:28
Applied terminal

As described in the instruction manual, use the shielded cable or twisted cable to avoid the influence of noises. More Details >>
- No：21344
- Release Date：2018/08/22 16:27
Capacity selection

Select the inverter capacity so that the rated output current of inverter ? rated motor current × 1.1. More Details >>
- No：21326
- Release Date：2018/08/22 16:27
Frequency setting

Up to 30 m. (To avoid noise and voltage drop)　　 More Details >>
- No：21910
- Release Date：2018/08/22 16:30
Frequency setting

The full scale of the frequency is initially set to 60 Hz and the frequency indication becomes the full scale at 60 Hz operation.To change the indication val... More Details >>
- No：21866
- Release Date：2018/08/22 16:29

141-150 of Total 295

Inquiries

page top