Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700 ]

261-270 of Total 295

prev 27 / 30page next

  • Parameter setting software

    The parameter setting software we provide is the FR Configurator (FR-SW3-SETUP-WJ). You must purchase it to use. Once you purchase the software, you can upgr... More Details >>

    • No：21673
    • Release Date：2018/08/22 16:28

  • Graph function in FR-Configurator

    Even the USB is used, FR Configurator requires at least 50 ms sampling time (for each monitoring item). In this case, since three types of data are monitored... More Details >>

    • No：21310
    • Release Date：2018/08/22 16:26

  • Amount of heat generated

    Refer to the FR-A700/F700/E700/D700 series TECHNICAL MANUAL (section 3.7.2) and the Technical News. The FR-A700/F700/E700/D700 series TECHNICAL MANUAL can be... More Details >>

    • No：21263
    • Release Date：2018/08/22 16:26

  • FR-A7NC E kit

    Not available. Differences between the parts supplied with the FR-A7NC and FR-A7NC E kit will result in improper installation. Use the FR-A7NC. Use the FR-A7NC. More Details >>

    • No：21258
    • Release Date：2018/08/22 16:26

  • DC reactor

    The 75K or higher DC reactor is included in the 75K or higher inverter. The option cannot be purchased separately. More Details >>

    • No：21252
    • Release Date：2018/08/22 16:26

  • Operation stop, frequency setting

    Set Pr.79 (Operation mode) to "1" (PU operation mode).　 More Details >>

    • No：21819
    • Release Date：2018/08/22 16:29

  • CC-Link

    To set the frequency via CC-Link communication, the NET mode should be selected. The new parameter setting is applied after powering OFF and then ON the inve... More Details >>

    • No：21763
    • Release Date：2018/08/22 16:29

  • Electromagnetic contactor

    It is not recommended to start and stop the inverter with the electromagnetic contactor (MC). This will accelerate the deterioration (due to the inrush curre... More Details >>

    • No：21322
    • Release Date：2018/08/22 16:27

  • CC-Link communication

    After setting Pr.79 (Operation mode selection) to "2" and Pr.340 (Communication startup mode selection) to "10", reset the inverter (or power ON again) to st... More Details >>

    • No：21256
    • Release Date：2018/08/22 16:26

  • CC-Link

    Check if the CC-Link wires are short-circuited and/or station numbers are duplicated.　　 More Details >>

    • No：21891
    • Release Date：2018/08/22 16:29

261-270 of Total 295

Inquiries

Contact Us

page top