Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-F700 ]

81-90 of Total 295

prev 9 / 30page next

  • Operation mode setting

    To enable the frequency setting with the setting dial and multi-speed setting, set Pr.79 to "3". Note that multi-speed setting is prioritized over setting us... More Details >>

    • No：21852
    • Release Date：2018/08/22 16:29

  • Frequency setting

    To accept the current signal, the terminals AU (current input selection) and SD must be short-circuited. Check it.Note that this terminal AU is not prepared ... More Details >>

    • No：21799
    • Release Date：2018/08/22 16:29

  • Motor specifications setting

    Yes.Set Pr.19 (Base frequency voltage) to "200 V".200 V output will be obtained during 60 Hz operation. More Details >>

    • No：21717
    • Release Date：2018/08/22 16:29

  • Frequency setting

    Yes, you can set Pr.20 to 20 Hz. More Details >>

    • No：21683
    • Release Date：2018/08/22 16:28

  • FR-RC

    Pr.30 = "1" and Pr.70 = "0". More Details >>

    • No：21143
    • Release Date：2018/08/22 16:26

  • Multi-speed setting

    Priorities are: Low speed (RL) > Middle speed (RM) > High speed (RH).For example, if the low speed (RL) and middle speed (RM) signals are input simulta... More Details >>

    • No：21772
    • Release Date：2018/08/22 16:29

  • Parameter setting

    Set Pr.55 (Frequency monitor reference) to "100 Hz".If the indication of the installed frequency meter does not match the running frequency, use the calibrat... More Details >>

    • No：21768
    • Release Date：2018/08/22 16:29

  • Brake resistor

    Use high-duty brake resistor FR-ABR-2.2K. (Shared with the 1.5K inverter.) More Details >>

    • No：21330
    • Release Date：2018/08/22 16:27

  • Wiring the terminal

    There is no problem with the wiring. Keep the rating (24 VDC, 0.1 A) of the terminal PC. More Details >>

    • No：21342
    • Release Date：2018/08/22 16:27

  • Switching between PU and NET operation modes

    Set Pr.340 (Communication startup mode selection) to "10".The operation mode can be switched between PU and NET by assigning X65 (PU-NET operation switching)... More Details >>

    • No：21878
    • Release Date：2018/08/22 16:29

81-90 of Total 295

Inquiries

Contact Us

page top