Installation dimensions of the heat sink panel through attachment

The heat sink panel through attachment to the FR-A520-5.5K inverter consist of the top installation frame, bottom installation frame, and upper cover. The to... More Details >>

Inverter signal input speed

There is a 10 ms delay after the inverter recognizes the start command (STF OR STR) before it starts decelerating. The delay is 10 ms. A delay of 100 ms is i... More Details >>

Automatic overload control of inverter

The inverter has the current limit function. This automatically controls the frequency so that the preset current value may not be exceeded. (Note that the m... More Details >>

Output phase loss alarm

If the output current is close to 25% of the rated current, output phase loss may occur when one or two phases of three phases go below 25%.Therefore, when a... More Details >>

Operation by single-phase power supply

Similarly to the FR-A220, single-phase power supply operation is possible by reducing the inverter's output current.Ensure that the output current is smaller... More Details >>

Countermeasure against oil mist

1. You cannot use the inverter in an environment where it is exposed to oil mist. 　You need to enclose the inverter in an enclosure and then install the encl... More Details >>

Functions available when using inverter on CC-Link

You can use the regular terminal block wire functions during CC-Link operation. 　Set Pr.338 (Operation command source) and Pr.339 (Speed command source) to e... More Details >>

Inverter stop-on-contact control

Use the FREQROL-A500 series inverter with the optional FR-A5NC.Then, you can implement both of stop-on-contact control and CC-Link operation. More Details >>

Fault output contact rating

They are capable of a load of 5 VDC±5% and 10 mA. More Details >>

Countermeasure against the fault occurrence

When a CC-Link communication fault occurs, the option error (OP3) occurs on the inverter and the output is shut off, and the motor starts coasting. When usin... More Details >>